Electronics Forum | Wed Dec 28 06:37:27 EST 2016 | luciano
Dear Anshang38, I actually don't have a profiler in order to get a new profile. I adjusted the machine once a coulpe years ago and did all regular maintenance and cleaning and it kept working fine until some weeks ago. I've changed all the flux and
Electronics Forum | Wed Jan 04 18:20:25 EST 2017 | ttheis
We recently ran a board with Mill Max surface mount spring-pins which placed perfectly straight from tape/reel but came out tilted in various directions after reflow. We're right within the recommended paste thickness of 0.005" and a reflow temperatu
Electronics Forum | Thu Jan 05 13:41:16 EST 2017 | huske
You have too much paste; I have used a lot of test points/spring contacts, etc. A single pin placement, especially one like this one that has a high lead to pad ratio, meaning 80% or more of the pad is covered by that single flat “lead” on the botto
Electronics Forum | Mon Jan 09 14:18:51 EST 2017 | ttheis
Thanks for your replies. Customer designed this so we can offer them feedback on the design. Pin manufacturer said most likely too much paste as well. Reducing apeture size would be the easiest solution there. We are running a VIP70 oven with chain r
Electronics Forum | Wed Jan 25 13:29:14 EST 2017 | emeto
you can check several things here: 1.Is this original tape or it is tape and reel service? 2. Is the cover tape that sticky, to lift component a little bit(sometimes might get the hole component). 3. Hole too loose, allow it to move too much 4. Fee
Electronics Forum | Tue Jan 10 10:48:10 EST 2017 | snevermind
I have a colleague trying to keep a piece of old equipment alive for a little longer. Web searches haven't been very helpful due to the age of the equipment. The latest listing I found was placed in 2013. Does anyone have a machine that could be p
Electronics Forum | Fri Jan 13 02:54:25 EST 2017 | roblackey
When the YV100 starts up if you press a key > during its startup you can get it to ascreen > where it asks for passwords.. > > How would you > get the passwords from this Hi, if you haven't changed them then I think it's "specialist" on VIOS.
Electronics Forum | Sat Mar 25 16:57:30 EDT 2017 | zippi
Hi, Our Company write a new software to Convert p&p files to assembleon text or xml file. We use it with an Ellipse 2, topaz X and an OPAL XII. You can check all positions compare with Gerber, set database number and compare component size, set fidu
Electronics Forum | Mon Jan 23 08:06:52 EST 2017 | bukas
i have an issue with solder bath temperature. there is a big difference in temperature of alloy in the middle of the bath and at the ends(about 35C). i took down heating elements for inspection and they look fine. its just that most of the heat is cr
Electronics Forum | Thu Jan 26 13:13:14 EST 2017 | dyoungquist
What type of solder are you using, Lead or Lead-Free? What is the melting point of it? What temperature are you setting your solder bath to? Possible solutions: 1) Give your solder bath a little more time to even out the temperature across the en