Electronics Forum | Wed Jan 05 21:22:13 EST 2011 | bajin
Where you are? http://www.esdcoats.net pls check if we are near from you.
Electronics Forum | Thu Jan 20 19:13:15 EST 2011 | jeffr
You should check that the machine actually works before you buy it. I still can purchase most parts, but the Vision Board is not available anymore.
Electronics Forum | Fri Feb 04 01:31:44 EST 2011 | fujiphil
Possible cause is the Middle Loading Sensor. Check the ML flag. Also, this problem occurs when the z-axis base slips. Need to level the base and re-calibrate z-axis origin.
Electronics Forum | Fri Feb 18 12:57:14 EST 2011 | hegemon
EIS has them P/N 2515-N LEAD-CHECK SWABS, 8 SWABS, 10BX/CS Manufactured By: ITW TECH SPRAY USD$ 29.53 Per 1 BX I have no affiliation with EIS `hege
Electronics Forum | Mon Mar 07 12:28:20 EST 2011 | rodrigo
I check the board options tab under the "General" menu and it is set to "no good". There is a "System Settings" that I can go into, but the button that says "Settings" is greyed out. The list shows that the marker is "installed". Neither the pen move
Electronics Forum | Mon Jul 23 20:03:19 EDT 2012 | hegemon
You'll need to login with Admin rights to apply those settings. Mirtec used to use pretty simple default passwords for admin as I recall. Check the manual, the default logins should be there. 'hege
Electronics Forum | Fri Mar 04 07:40:49 EST 2011 | tony_d
Mike, Do yourself a favor and check out MIRTEC. As far as I am concerned, they have the best damn table top AOI on the market. There is so much information in this forum to support this claim. Just my two cents... Tony_D
Electronics Forum | Thu Mar 17 09:36:42 EDT 2011 | swag
We inspect incoming stencils to see if they are labelled properly and sometimes check the width of special apertures and that's about it. We want to kick it up a notch. What are others out there doing to inpect incoming stencils? Is there criteria
Electronics Forum | Fri Mar 25 08:54:59 EDT 2011 | mosborne1
Have you checked your reflow profile? You need top make sure that you are with the specification of the solder paste. We currntly use the Kic thermal profiling device.
Electronics Forum | Mon Mar 28 03:38:17 EDT 2011 | Nigel, RAKON
Graham, good idea about reflowing first. I'll try this out. Our product is Ceramic, not PCB. I'll check the reflow as you say, though I have trialed various shapes and I am in contact with stencil manufacturer regarding aperture sizing. Thanks.