Electronics Forum | Sun Aug 10 03:41:20 EDT 2008 | eyalg
Thanks for your promt reply It was very usefull Eyal
Electronics Forum | Sun Aug 10 03:39:21 EDT 2008 | eyalg
Thanks Pete yes we usu ROHS solder paste in our process. I agree that this termination is more suitable for adhsive bonding rather than soldering. We'll try changing the termination type as you recommended. Eyal G
Electronics Forum | Fri Aug 08 09:49:17 EDT 2008 | scottp
We've seen the exact same problem. The solder joints had negative wetting angles and x-sections show that the PdAg termination dissolved into the solder. We no longer allow PdAg terminations.
Electronics Forum | Thu Aug 07 10:02:10 EDT 2008 | eyalg
We are facing low quality due to soldering opens with coilcraft inductors 0402CS-2N7XGLW. The termination used is(suffix L =RoHS compliant silver-palladium-platinum-glass frit. Did anyone had this problem in the past? Can we do better using T = RoH
Electronics Forum | Thu Aug 07 11:58:36 EDT 2008 | pbarton
We have experienced the same problem with Pd/AG and P/Ag terminations on precision resistive parts. The problem is dissolution of the termination metallisation into the bulk solder. This is exacerbated by the higher thermal profiles required for RoHS
Electronics Forum | Wed Aug 27 23:00:55 EDT 2008 | omid_juve
i mean that the parts that we have here is ROHS compliant(pb free)but the process that we have(the type of solder paste & the surface finish of the board has pb in its mixture) this is not the cause of problem ?
Electronics Forum | Fri May 27 08:11:27 EDT 2005 | Joris Groot Koerkamp
I have a problem with a Murata cap chip type resonator(ROHS). After the reflow process, the soldering joints flow to one side of the component. I did not have this problem with the leaded component. Did someone have a solution for this problem?
Electronics Forum | Thu Aug 28 11:15:05 EDT 2008 | omid_juve
I've been there. Soldering no lead parts in a > leaded world can be difficult. Sounds like you > are not wetting to your parts becasue you ar enot > getting hot enough. Here's the trick - you can > turn up your profile to look like a no-lead
Electronics Forum | Mon Nov 24 11:19:21 EST 2008 | sjones
I am having problems soldering a Rohs compliant BGA ATMEL AT91RM9200(rohs compliant board) This device recommends a soldering profile from J-STD-20 and a minimum peak package temperature of 250 centigrade,peak 260. However a lot of the other componen
Electronics Forum | Mon Nov 24 11:26:08 EST 2008 | sjones
I am having problems soldering a Rohs compliant BGA ATMEL AT91RM9200(rohs compliant board) This device recommends a soldering profile from J-STD-20 and a minimum peak package temperature of 250 centigrade,peak 260. However a lot of the other componen
.gif)
winsouce.jpg)