Electronics Forum | Tue Mar 30 12:27:40 EDT 2021 | chicagoindustrial
This is correct. We don't know if you are looking across the components or referencing a point they are not even connected to.
Electronics Forum | Thu Dec 17 08:27:09 EST 2020 | gort
Hi all Wonder if anyone can help , I'm trying to test a pcb board ( with very little experience) I've tested the resistors and now the capacitors , only to find that about 5 of them have continuity so guessing there not working . I checked the s
Electronics Forum | Thu Dec 17 10:54:43 EST 2020 | spoiltforchoice
Unless you have a firm grasp on the circuit and electronics in general, you are on a hiding to nothing. Testing components in circuit is complex, because its a circuit and any measurement you make is affected by connected neighboring ones. If you set
Electronics Forum | Wed May 21 12:26:24 EDT 2003 | Michael Ling
If I need to test whether our products can withstand the solder reflow process, is there any tests that I can perform other than putting the products through the actual relfow process.
Electronics Forum | Thu May 22 00:21:27 EDT 2003 | AlCapone
The alternative is by looking at all your components data specs (heat-range), especially pay more attentions to heat-sensitive comps, and fine-pitch comps, odd-form comps, draw a diagram on a separate sheet of paper shown that temperature VS those ca
Electronics Forum | Mon Aug 02 16:54:07 EDT 2004 | davef
If you eliminate this test, how would you monitor the cleanliness of your: * Bare boards * Components * Processes You probably could get a c of c from your board fab, but a c of c from the component suppliers would be burdonsome [and agruably useles
Electronics Forum | Wed Jul 06 07:58:23 EDT 2005 | davef
Most component fabricators provide this information on their component data sheets.
Electronics Forum | Fri Feb 11 10:25:20 EST 2005 | Daniel Peeters
Yes, that I know. But we have been asked to test the component when it comes out of production, before it would be taped. any clues? Regards, Daniel Peeters
Electronics Forum | Fri Feb 11 09:10:39 EST 2005 | davef
Welcome to the forum. Yes, there is a wide range of equipment types that can be used to measure the function of components after the board is assembled. Look here for test: http://circuitsassembly.com/bguide/
Electronics Forum | Thu Jul 21 08:58:48 EDT 2005 | Rob
Hi, Has anyone got any experience with Lead Check or any other type of swab system for checking the presence of lead on a component or assembly? http://www.leadcheck.com/CircuitBoard.shtml Cheers, Rob.
.gif)
