Electronics Forum | Fri Jun 16 10:12:16 EDT 2006 | flipit
It it PSA tape or heat seal? Every machine I have ever used has trouble with PSA cover tape. I wish they would ban in in ROHS. 3M tells me it is the future and it will replace heat seal tape.
Electronics Forum | Thu Jun 15 03:31:26 EDT 2006 | Bert van den Berg
The cover tape on 0805, 1206 and IC reels occasionally does not pull back clear of the tape and our Fuji IP-1 stops. Although some feeders appear to be more vulnerable to this than others, is this a feeder problem or is this a material problem with
Electronics Forum | Thu Jun 15 08:44:18 EDT 2006 | jdengler
Bert, The original IP feeders do a poor job of peeling the cover tape. Things to check: -All teeth present on the take-up reel -Take-up reel has even drag as it rotates (reel out of round or dirty) -Take-up reel drag is not too high (locations and
Electronics Forum | Thu Jun 15 04:02:30 EDT 2006 | Rob
Hi Bert, It can be either - sometimes they put too much glue on the cover tape when it's sealed, and sometimes the feeder is not stong enough. We would get a lot of these on our fuji's after a shutdown, and they would diminish throughout the first
Electronics Forum | Fri Jun 16 15:50:08 EDT 2006 | Bert van den Berg
PSA - Pressure Sensitive Adhesive? I don't know which type of tape the affected reels of parts use but it is not sticky. Thanks everyone for the comments and suggestions. There were no missing teeth on the plastic take-up reels. I have cleaned an
Electronics Forum | Thu Aug 13 14:43:23 EDT 2015 | alphatronique
HI i try to figure how the "Manual load adapter" work on a T3 Table machine ? seem that the table always try to move the board to the the left sensor location ,but if i use the magnet manual table it will never find the board on the table convey
Electronics Forum | Fri Nov 04 20:25:47 EST 2005 | mika
Always happy to share information. Perhaps other viewers on this thread, can get some ideas of "how to". /Sincerely Ps. There is a so called "standard height" which the conveours/machines from different manufactories must be able to reach; without r
Electronics Forum | Mon Mar 20 08:36:30 EST 2006 | jdengler
I've never had this problem on an Omniflo oven, but have seen it on others. It has always turned out to be mechanical. A bearing going bad or FOD in the rails. I would pull the chains and carefully check each link of both chains, all of the bearin
Electronics Forum | Tue Oct 01 11:48:01 EDT 2013 | bengt
Hi All. We have bought EKRA E4 screenprinter. We are running R to L and printer has L to R direction. Does anyone can help me on this ? On specs it says all kind of directions.
Electronics Forum | Sun Oct 06 12:18:03 EDT 2013 | christian01976
Hello! Go on the Service Button (bottom right) password could be 2211 or 9060. In that menu you should be able to change direction. Please tell me if it works! Bye Christian
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
.gif)
.gif)
winsouce.jpg)