Electronics Forum | Sun Oct 30 06:13:23 EST 2005 | mika
I am sorry for my poor english, but perhaps you will undertsand:-) The important thing is to get the conveyors straight: The front fixed rail must be parallel with the next one and also the heigt. The heihgt of the prior conveyour should be (but not
Electronics Forum | Fri Jan 14 09:36:49 EST 2000 | Richard
If the gold fingers are pad types which plug into expansion slot connectors, I have used a titanium guard attached to the wave conveyor over the solder pot, which allows the PCB to connect to the fingers but masks the solder from the gold pads along
Electronics Forum | Wed Oct 10 13:13:44 EDT 2007 | jsloot
Any body using any kind of special finger marker stickers used to check wave solder conveyor fingers parellism? If so please contact me.
Electronics Forum | Fri Jan 25 16:07:07 EST 2002 | davef
On your coating ... * What is the material coating? * What is the purpose of the coating? So, is this coating something that was on the fingers on your conveyor and is now transmigrating to your boards? We replace 20 of our titanium fingers on our
Electronics Forum | Fri Apr 12 07:40:50 EDT 2019 | krob
We have found that our wave solder will produce worse hole fill/top side fillets nearest the conveyor, on most boards. I believe this is due in part to the smaller contact patches near the conveyor fingers. What could cause this reduced contact
Electronics Forum | Mon Dec 12 22:14:42 EST 2005 | davef
�a va Frank? Well, popularity depends on the beholder. Never heard of your "Specnor" machine. US and Eurolanders take different approaches to conveying boards. * US: Finger conveyors * Eurolanders: Pallet conveyors Suppliers of wave solder machin
Electronics Forum | Fri May 02 11:09:13 EDT 2014 | pawloa
Hello. We have a Minipak 300 wave solder machine from Electrovert and are looking in particular for a tachometer that attaches on the finger conveyor motor to measure the speed in pulses. We are also looking for the thermocouple that is used to moni
Electronics Forum | Tue Jul 03 11:56:13 EDT 2001 | Russ Roberts
I am a Manufacturing Engineer working on a new bid. Please help with my question about a new process that I am unfamiliar with: The Assy that we are quoting involves a SMT PCA that is soldered to an aluminum chassis. All surfaces of the chassis that
Electronics Forum | Fri Feb 16 02:00:12 EST 2001 | PeteC
Dreamsniper, The optimum contact (dwell) time in the wave should be 2 seconds. Contact band width is a function of conveyor speed. For an example, 5cm of contact band width at 150cm/min. conveyor speed will give you 2 seconds of contact time and 2cm
Electronics Forum | Tue Jan 25 16:39:13 EST 2005 | russ
Do you have manuals for any aother wave machine? If so just use that, they are all pretty much the same. dedross daily, clean nozzles and heating elements monthly, straighten/replace fingers as required, clean and lube conveyor semi-annualy, etc...
.gif)
