Electronics Forum | Tue Oct 21 08:06:15 EDT 2008 | maheshbs
I have problem in Jot Automation inspection conveyor. The Problem is that the Good board has to go in down side conveyor & Bad board has to go in upside for rejection or rework. It is unable to separate the good & bad boards. Kindly refer the attachm
Electronics Forum | Wed Oct 22 01:14:04 EDT 2008 | maheshbs
Conveyor is installed after AOI machine. After inspecting the board in AOI it sends the signal to the conveyor whether it is Good board or Bad board.
Electronics Forum | Tue Oct 21 13:49:06 EDT 2008 | ccouture
How does the conveyor know if a board is good or bad?
Electronics Forum | Sun Oct 30 06:13:23 EST 2005 | mika
I am sorry for my poor english, but perhaps you will undertsand:-) The important thing is to get the conveyors straight: The front fixed rail must be parallel with the next one and also the heigt. The heihgt of the prior conveyour should be (but not
Electronics Forum | Tue Apr 15 08:38:23 EDT 2003 | pjc
Don't have any specific links to papers and articles. Try searching on the IPC.org (plus APEX show http://www.goapex.org) and SMTA.org web sites. Any papers and articles on the process from equipment mfg.'s should be taken with a grain of salt. Sold
Electronics Forum | Thu Oct 20 19:23:18 EDT 2011 | eadthem
As far as the buttons go, White = pause for inspection when depressed, lit when active Green = pass after inspection when lit you need to press the button, when flashing its waiting for the upline machine, Yellow/orange = when flashing indicates
Electronics Forum | Sat Aug 11 16:40:04 EDT 2012 | johnyq
We have a Bosch Edge Pro inspection conveyor. We are trying to get information about it. Is Bosch still in the conveyor business. Does anyone know how to contact them? Thanks.
Electronics Forum | Wed Jan 20 09:12:03 EST 2016 | anel_elektronik
Hallo, Following problem with CP40CV conveyor: If I start production, put first PCB and after placement PCB is transported to the output of conveyor and I take it out. Next PCB after placement is waiting endless. All sensors are ok. Looks as if t
Electronics Forum | Tue Oct 07 12:40:57 EDT 2003 | ssnow
OEM no longer in existence. hard to find exact match. belt is flat and green. used for PCB transport.
Electronics Forum | Mon Oct 06 18:24:34 EDT 2003 | pjc
what type of belt is it and what material is it? round belt, flat belt, etc... if its from a PCB transport conveyor or other PCB handling system, I recommend you contact the OEM. I have spliced belts before- rubber round belt off old Fuji loader and
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
.gif)
.gif)
