Electronics Forum | Tue Sep 01 12:47:37 EDT 2009 | rodrigo
Hi all, Our IPII just developed yet another issue. The PCB goes in the conveyor and when in the loader, the lifter goes up and after a few seconds I get a lifter cycle alarm error. I checked the in/out screen and when I make the lifter go up, the se
Electronics Forum | Thu Sep 09 04:00:22 EDT 2004 | rlackey
Hi Peter, You certainly have a selection of kit. We use 2 CP6's & 2 GSMs per line, and that balances pretty well (sometimes one of the fuji's is idle though - but we can live with that). When we had S20's we found 2 of them roughly kept up with a
Electronics Forum | Thu Apr 13 10:05:47 EDT 2006 | daxman
Okay fellas...I posted awhile back regarding CP4 and CP6 placement issues. I think we may have figured it out. XO/YO and mark read positions were not correct. However, we have a new problem with the CP4-2. I was running the Fuji board, placing a s
Electronics Forum | Wed Mar 20 13:49:15 EST 2002 | cabjerk
Hi All; The following is from our Support people who worked with Fuji on the problem; Last week Luke Mittur and John Gudel were in from Fuji to address the IP3 issue outlined below. The problem ended up being that the table "up" and table "dow
Electronics Forum | Thu Jun 27 14:56:05 EDT 2013 | kdc45
Purchased 2 used Fuji CP43's and did not receive manuals with them. Have been using CP42 manuals to write procedures and looking for jigs for the vision systems to calibrate them. However, I cannot find the jigs with the part #'s that are in the CP42
Electronics Forum | Tue Oct 11 17:01:05 EDT 2005 | russ
Pulling 16CFM out of a 25 CFM compressor will definitely make it run all of the time.
Electronics Forum | Tue Dec 13 07:13:28 EST 2022 | bukas
same happens with older series. clean connectors again, also clean slots. once(out of 100 times) i had this problem on my CP45 and it turned out to be corrupted data on HDD. so good luck, dont think out of box, think out of room.
Electronics Forum | Sun Jan 29 02:33:36 EST 2006 | daxman
Hello all, I work with a company which runs a fairly small SMT department. For now, we have a "main" line consisting of a Fuji CP6-45, and a Fuji IP3, and a proto line which uses a Fuji CP4. We also use Fuji Flexa programming software. The issues
Electronics Forum | Mon Aug 31 13:31:09 EDT 2020 | bukas
when something like this happens I usually do a connector and PCB slot cleaning. apply contact cleaner and plug/unplug (slot/unslot) connector (PCB) few times then blow it out dry. do it for each PCB and connector.
Electronics Forum | Thu Mar 09 00:45:57 EST 2006 | kent_peterson
Fastek will get it done with 2 machine and 2 shifts. 2 shifts would need to place 50,000cph. One CP643 with both device tables set could get it done. Having it panelized in 50's, you would need to print 50 panels a hour so get a auto cleaner on the p