Electronics Forum | Fri May 30 08:24:08 EDT 2008 | cyber_wolf
The nozzles get centered at zero degrees and 180 degrees. I believe the yellow asterisk is the measurement at zero degrees, when it rotates to 180 is when you will get a red X or a green O. (In other words the yellow asterisk is normal) I think you
Electronics Forum | Thu May 29 14:57:26 EDT 2008 | rodrigo
Hi all, Is it normal for some of the small nozzles to be rejected by the wide view camera? Every time I do a nozzle centering the narrow view camera shows green circles for nozzles 1,2,3,4. The larger ones (5 and 6) show the asterisk. The wide view c
Electronics Forum | Fri Feb 25 16:34:53 EST 2005 | jimmyb
In your PDs you must specify a single nozzle size. Meaning don't assume that entering nozzle size max=1.3 and nozzle size min=1.3 forces the machine to use a 1.3. Nozzle size min is not used in the CP6 software (it only uses nozzle size max), there
Electronics Forum | Thu Jun 14 16:31:38 EDT 2007 | aj
I concur Chunks ! A simple test to carry out is the Z0 height check across the board, with particular attention to the area of the board you are having problems. You should at least see the nozzle touch the board , ideally press the board slightly.
Electronics Forum | Mon Feb 28 08:34:46 EST 2005 | Alex
Good advises thanks. I'll go thru all nozzles and vacuum check today and tell the programer about PD's and nozzle vs shutter. Should I check at the same time all the vacuum filter ? For the placement test, we use the same feeder at the same position.
Electronics Forum | Mon Aug 21 10:47:48 EDT 2006 | FredC
Hello Mika, I just checked a windmill and a test nozzle we have on the bench. The useful travel of the nozzle before the risk of the crosspin getting stuck in the loading gate is 1.5mm, if it gets stuck it is the nozzle is 1.7 up. If the cross pin is
Electronics Forum | Wed Sep 11 01:17:59 EDT 2002 | Brian Sloth Bentzen
Hi Steve. My Fuji CP6 is model 643 and are 3 years old, maintained and upgraded with the newest software along the way. And, actually it was Fuji Japan that gave in, not Fuji America. Fuji Japan tested our components and found the same problem and
Electronics Forum | Sat Aug 19 21:06:09 EDT 2006 | mika
Hi all, At our Fuji CP-6 machines we place a lot of 0402:s, 0603:s and 0805:s chip capacitors. Our problem is that the height of the components can sometime be very extreme from different vendors. I am sure you all have experience of this phenomenon
Electronics Forum | Tue Mar 04 11:47:58 EST 2003 | msivigny
Hello John, Your second statement is a little vague about the 16th card shutting down the line with the 2x240 QFPs misplaced... i'll try to interpret, assuming the cards are actual product, which I think they are, your 16th card failed because 2 out
Electronics Forum | Sun Oct 04 08:07:53 EDT 1998 | jvo
| I am experiencing solder paste comtaminatin of nozzels on 0603 size components resulting in missing components. The machine is failing to alarm under these circumstances. Has anybody else experienced this problem & found a solution? | Check if you
.gif)
