Electronics Forum | Fri Apr 08 09:42:31 EDT 2022 | bukas
thanks for help guys. I changed HDD and mounted image from a working machine then I ran a calibration. It still moves paste left and right but distance is much smaller so prints are acceptable. I have a spare vision card will try it tomorrow. Do I ne
Electronics Forum | Wed Dec 19 12:31:14 EST 2012 | emeto
1. Check for pins or something else under the rails. 2. Check the motor for the axis and the sensor that defines up position(I doubt it there is an encoder for this motor) 3. check card 4. check interface cable
Electronics Forum | Fri Aug 24 02:40:52 EDT 2018 | bukas
first check fuses in Y1 case. thats where EuroSYS cards are, and message you get tells you that cards can not communicate with main processing board in Y3 case via RS485. after that check cables and connectors. there are 4 EuroSYS cards in Y1 case, t
Electronics Forum | Tue Mar 22 13:00:37 EDT 2022 | bukas
hi, I have a 265GSX machine that prints firs PCB in batch correctly and then missprints the rest(there may be acceptable prints by accident). after hitting END RUN and RUN again, first PCB comes out perfect but others are bad. paste is randomly shift
Electronics Forum | Sat Aug 13 22:55:11 EDT 2022 | dekhead
Most likely an issue with vision system, or communication therewith... But with # of combinations of CPU, Cognex and cameras, would prefer off forum contact to sort it out. email sent.
Electronics Forum | Tue Mar 20 05:03:47 EDT 2012 | sunyb123
Dear sir, i have face same problem of motor Communication fail Card0,Card1,I Clean Whole card properly, change the battery new one ,reprogrammed mint, but Card 2&Card3 loaded the mint programmed but not in card 0 & card 1, Please suggest what to d
Electronics Forum | Mon Nov 29 13:01:35 EST 2004 | bobsavenger
I have a DEK 265LT screen printer and a Fuji bare board loader. I cannot get the two machines to talk through the SMEMA cable. I have the personality card for the DEK and I have the correct cable for a FUJI machine. Is there something that I nee
Electronics Forum | Tue Mar 20 05:29:13 EDT 2012 | menatech
Hello, the cards have bit switches adresse from 0 to 3. Can you check them? Slot 1 is card 0, Slot 2 is card 1 .....
Electronics Forum | Tue Mar 20 09:25:35 EDT 2012 | dekhead
If problem is jumping from card to card; my direction would be 5vdc level. generally like it to be min of 5.15vdc on the MINT cards (top lead of 7-segment display). www.dekhead.com
Electronics Forum | Mon Sep 02 23:56:08 EDT 2013 | dekhead
Looks like too many signals there for a DEK SMEMA board to handle; trying to translate / ascertain what signals those are, to offer possibilities to communicate with DEK; However would pretty much guarantee a need for hardware change (personality car
