Electronics Forum | Tue May 29 08:37:52 EDT 2018 | bukas
screen alignment chase clamp state is ON, it can be turned OFF but when I get out of diagnostics machine turns them ON again. Tooling is set to magnetic, and on other machines I have chase clamps are not energized all until board is in machine and st
Electronics Forum | Thu Aug 23 10:16:43 EDT 2012 | dontfeedphils
There are a couple of things that I would check. Check the board clamps and make sure that they're in good shape and that they're actually holding the board securely. If those check out I would take a look at the fid camera and make sure that every
Electronics Forum | Tue Jul 22 13:45:19 EDT 2008 | gemengr
any one know the part# for the cable that clamp the stencil??
Electronics Forum | Fri Feb 16 21:51:15 EST 2024 | jborrelli76
I was correct...the cable that operates the stencil clamps on the right bank is severed...do you know where I can get a replacement cable part number 163368? Thanks.
Electronics Forum | Fri Feb 16 17:04:17 EST 2024 | jborrelli76
Thanks, will do. The point that's odd is one side functions. I think there may be a cable that causes each bank to clamp that may be broken. Time to get my hands dirty...
Electronics Forum | Mon Nov 29 13:01:35 EST 2004 | bobsavenger
I have a DEK 265LT screen printer and a Fuji bare board loader. I cannot get the two machines to talk through the SMEMA cable. I have the personality card for the DEK and I have the correct cable for a FUJI machine. Is there something that I nee
Electronics Forum | Tue Oct 13 16:26:26 EDT 1998 | Earl Moon
| | We suffered our first blood letting because of razor sharp edge clamps (DEK 265LT) and operator giving it the finger. While positioning magnetic tooling pins, one of our best slipped and really sliced off a part of his main digit. This will impac
Electronics Forum | Tue Oct 13 12:58:18 EDT 1998 | Justin Medernach
| We suffered our first blood letting because of razor sharp edge clamps (DEK 265LT) and operator giving it the finger. While positioning magnetic tooling pins, one of our best slipped and really sliced off a part of his main digit. This will impact
Electronics Forum | Wed Oct 14 05:32:24 EDT 1998 | Tony B
| | | We suffered our first blood letting because of razor sharp edge clamps (DEK 265LT) and operator giving it the finger. While positioning magnetic tooling pins, one of our best slipped and really sliced off a part of his main digit. This will imp
Electronics Forum | Tue Aug 29 21:14:45 EDT 2006 | Bubba
You need a machine with side clamps. DEK makes them. MPM makes them. Look into a retro for your machine. Both take up space on top of your board. Be carefull of top side component clerance if switching.
