Electronics Forum | Fri Sep 07 17:13:54 EDT 2012 | burb1999
Run the calibration screen/procedure. I have had where the camera was hit etc.. and caused a misalligned print.
Electronics Forum | Thu Aug 23 10:16:43 EDT 2012 | dontfeedphils
There are a couple of things that I would check. Check the board clamps and make sure that they're in good shape and that they're actually holding the board securely. If those check out I would take a look at the fid camera and make sure that every
Electronics Forum | Thu Aug 22 04:08:17 EDT 2002 | Jason Baldwin
Symptom: Board Stuck on Print Conveyor error messages. Cause: Board not flagging the camera sensor. Remedy: Check the following items: � Check the camera sensor can see the board underneath. � Check the camera sensor calibration (in Tools, Camera Re
Electronics Forum | Mon May 02 21:26:23 EDT 2022 | rob1
I have a problem with DEK 265 Horizon. During camera being homed after checking the fiducials, the camera failed to home properly and crashed into the back of the machine in the Y direction. I homed the camera in the Y and it appeared OK and I could
Electronics Forum | Tue Mar 23 16:37:23 EDT 2010 | mmjm_1099
Hello all, I am currently looking for either the CMOS chip for one of the smaller pcb boards within this camera or a used graphite camera. Please email me mmartinjr@ymail.com
Electronics Forum | Thu Apr 20 14:37:29 EDT 2006 | Chunks
The newer MPMs use the camera to find the board edge - no mechanical stops like AP and DEKs.
Electronics Forum | Fri Jun 03 20:21:56 EDT 2016 | sonavc
Thanks , I fix this problem. Now I know the boards stop near by camera.
Electronics Forum | Fri Aug 28 11:39:23 EDT 2015 | dlee87
I have an issue with this DEK printer our company > has been having for over a year now. It seems > that DEK can’t narrow down what the issue > actually is as well. The printer is a DEK Horizon > 03i 09 SP13 P02. We are having an issue with
Electronics Forum | Sat Sep 06 07:20:37 EDT 2014 | gascon5383
I have an issue with this DEK printer our company has been having for over a year now. It seems that DEK can’t narrow down what the issue actually is as well. The printer is a DEK Horizon 03i 09 SP13 P02. We are having an issue with the camera.
Electronics Forum | Tue May 28 12:56:22 EDT 2019 | dekhead
It is a communications failure between the CPU and the Cognex card. Does comms initiate between the 2 cards (flashing green on both)? or does it immediately come up red LED on Cognex? Have you reseated the CPU board as well as the Cognex? Is this a s
