Electronics Forum | Tue May 29 08:37:52 EDT 2018 | bukas
screen alignment chase clamp state is ON, it can be turned OFF but when I get out of diagnostics machine turns them ON again. Tooling is set to magnetic, and on other machines I have chase clamps are not energized all until board is in machine and st
Electronics Forum | Fri Feb 02 15:22:32 EST 2024 | carl_p
Machine a clamp into or from the FR4. to Tension the boards into place
Electronics Forum | Mon Jan 29 13:11:31 EST 2024 | erikfriesen
I'd like to build my own carriers using tg fr4 as we have in house Cnc. Where can I find flush corner clamps? Or are these typically custom manufactured by individual carrier board manufacturers?
Electronics Forum | Mon Dec 20 07:09:03 EST 1999 | Christopher Lampron
Ron, The simplest way to process fexible PCB's that I have found is to use a process carrier fixture. There are companies that manufacture process carriers that are capable of holding flex through stencil, placement and reflow. The carriers are capab
Electronics Forum | Thu Aug 23 10:16:43 EDT 2012 | dontfeedphils
There are a couple of things that I would check. Check the board clamps and make sure that they're in good shape and that they're actually holding the board securely. If those check out I would take a look at the fid camera and make sure that every
Electronics Forum | Tue Oct 13 16:26:26 EDT 1998 | Earl Moon
| | We suffered our first blood letting because of razor sharp edge clamps (DEK 265LT) and operator giving it the finger. While positioning magnetic tooling pins, one of our best slipped and really sliced off a part of his main digit. This will impac
Electronics Forum | Tue Oct 13 12:58:18 EDT 1998 | Justin Medernach
| We suffered our first blood letting because of razor sharp edge clamps (DEK 265LT) and operator giving it the finger. While positioning magnetic tooling pins, one of our best slipped and really sliced off a part of his main digit. This will impact
Electronics Forum | Fri Apr 18 11:52:25 EDT 2008 | leemeyer
I am looking for some sources for a reuseable thermocouple probe. We do small prototype runs and many times cannot afford to be scrapping boards for profiling. I am looking for a probe that will clamp to a pcb or pcb carrier and allow me to manipulat
Electronics Forum | Wed Oct 14 05:32:24 EDT 1998 | Tony B
| | | We suffered our first blood letting because of razor sharp edge clamps (DEK 265LT) and operator giving it the finger. While positioning magnetic tooling pins, one of our best slipped and really sliced off a part of his main digit. This will imp
Electronics Forum | Tue Aug 29 21:14:45 EDT 2006 | Bubba
You need a machine with side clamps. DEK makes them. MPM makes them. Look into a retro for your machine. Both take up space on top of your board. Be carefull of top side component clerance if switching.
