Electronics Forum | Mon Apr 11 06:54:03 EDT 2011 | mosborne1
Wipe off your linear scales and clean your quadalign lense.
Electronics Forum | Mon Apr 11 15:57:25 EDT 2011 | bobpan
If the feeders that you are having problems with have tall parts in them.....and these are the ones the machine is stopping on.....check to see that you are not scanning higher than what your function 30 nozzle height is. In other words...if your fun
Electronics Forum | Mon Apr 11 08:27:10 EDT 2011 | leemeyer
I have had similar problems before where the machine will intermittently stop with a limit error. Reset the machine and away it goes. Replacing the ribbon cable that runs from the head (37 pin D-sub)has solved this problem. This cable gets flexed a l
Electronics Forum | Fri Apr 08 21:39:17 EDT 2011 | jimlas53
Hi, We have a Quad IVc set up with all picks, placements, and sequence working. I have managed to get through several passes with some pain, mainly from SOT-23 parts, but it is getting better. On occasion, when picking from one of three feeders loc
Electronics Forum | Tue Apr 19 14:58:05 EDT 2011 | rdoss
The ribbon cable would be my guess. I ran a IVc for about 3 years and we use to have to change out our cable at least once per year. I also wanted to add that you can contact Precision Placement Machines (PPM) for parts and service. We use to use
Electronics Forum | Thu Nov 21 11:51:28 EST 2013 | dekhead
Best guess, not knowing specifics of error, would be a vision system error... connection issue wrt camera. Does system respond properly (prompts to raise / lower head) upon reboot? Specific error information would help in troubleshooting. DEKHEAD
Electronics Forum | Mon Nov 18 02:45:06 EST 2013 | sara_npi
Hi What is "fatal error"? Every time when operator raise head to add cleaning paper or add solvent machine just hang like that. need to reboot machine. Pls advise Thanks.
Electronics Forum | Tue Mar 20 12:33:08 EDT 2018 | edjeske
how do i clear this error?
Electronics Forum | Tue Mar 20 18:28:26 EDT 2018 | dekhead
Print Head Stroke Calibration?
Electronics Forum | Wed Mar 21 19:35:38 EDT 2018 | dekhead
Not sure what blowing an airline would have to do with this; I sent you an email to get information on machine specifics for the procedures you need.