Electronics Forum | Thu Feb 21 18:43:35 EST 2019 | dekhead
Are you saying that it works in print mode and not in pass thru mode? Or that is won't pass boards downline regardless?
Electronics Forum | Wed Aug 30 08:06:45 EDT 2006 | scombs
The reason I asked earlier about Gridlok is that we are using the on 2 Dek Horizon printers (since Jan 06) with edge clamps and they work well. We run them in Auto mode so they conform to the board at each print so I do not have to worry about the op
Electronics Forum | Sat Feb 19 06:56:56 EST 2022 | nikevoo1
Glue dispenser Fuji GL-V should have PASS and PRODUCT mods. But the PRODUCT mode its gone. There is only PASS mode and we cant change it. I tryed to replace the CPU board but the problem stayed. Any ideas?
Electronics Forum | Tue Apr 16 20:38:03 EDT 2024 | digitalshovel
when in assign mode, set npm1 as pass. The condition set will make it pass through to npm2
Electronics Forum | Mon Mar 24 14:19:36 EDT 2008 | burb1999
I have a DEK ELA and here is what happens. I print a board after going through the step and it is a dead on print. Then, with another print it will be off in Auto mode (sometimes up and sometimes down, seems to just be up and down not left to right
Electronics Forum | Tue Mar 25 14:27:16 EDT 2008 | smtnet51
Make sure whatever you are using for a fid. is apart from any other pads or apertures. It'll grab a pad/aperture above or below (in auto mode) and screw up your print. We saw this alot when using pads for fids on DEKs.
Electronics Forum | Thu Feb 21 16:53:32 EST 2019 | bane016
I don't know...but at DEK horizont i2 , i3 and ASM have option in machine settings "print/no print....if you check "no print" machine work in passthrough mode...
Electronics Forum | Wed Jun 21 04:11:31 EDT 2006 | daxman
Are you familar with using the mecca mode on Fuji machines? There is a procedure I can take you through that will check the servo amp and allow you to adjust it. Is your machine useable at all? can you get it to pass zero set? If you can, view your s
Electronics Forum | Sun May 02 17:58:21 EDT 2010 | bruceb
When my DEK 265GSX boots I get a vision error1 and am asked to reinitialize. I cannot get into mainenance mode to troubleshoot. DEK told me over the phone that I have a bad Cognex card and it would be $20k to repair. This is crazy, has anyone seen th
Electronics Forum | Tue May 31 16:31:02 EDT 2011 | xray
Hi, Besides the 2 machines mentioned which are part comparison machines that require the operator to provide a pass/fail on each ref id, there is a system called the FA Inspector which offers the mode described above and two additional modes: 1. Au
