Electronics Forum | Tue Dec 21 13:27:47 EST 1999 | Vince Whipple
Charlie: As far as setting up a spray fluxer.. Are you spraying no-clean, voc free, water soluble? What you would want to do is to run a blank pcb through the fluxer and pop it out before the preheaters. Visually inspect for variations in uniformit
Electronics Forum | Thu Dec 23 22:31:47 EST 1999 | Vincent Chen
Hi!Charlie, 1.Are you retrofitting your spray fluxer in your wave soldering machine? If you are, please ensure that you have a air knife just before the preheater!Fluxe fumes tends to accumulate and that could be dangerous if your air exhaust is not
Electronics Forum | Thu May 27 13:18:30 EDT 2004 | swilson
Hello does anyone have a schematic or service manual on setting up a foam fluxer on the 650C wavesolder machine. I am concerned with the two pumps in the rear of the machine what are the connection for on the pumps. I do have the manuals, but they do
Electronics Forum | Thu May 27 13:40:20 EDT 2004 | pjc
The pumps are for a Flux Density Controller FDC550. Contact Speedline Tech.- Electrovert to get a manual. 800-737-8110.
Electronics Forum | Wed May 21 00:28:42 EDT 2008 | grayman
Hello, My Friend from USA wants to set up new factory for SMT production (expansion line). Currently, he has production lines in the USA (10 lines with testing). Initially, he will set up 3 lines to produce power supply like AVR and UPS. He doesn't
Electronics Forum | Sun Apr 07 00:45:21 EDT 2019 | d_nguyen2018
Hi, Can you show me how to set up tray table? I have 1 x 10 pockets tape with 10 PQFPs. I went into Magazines then selected Tray Wagon. I did first and last part on the 1 x 10 tape pockets but it did not work. I was told that I must set up the tray
Electronics Forum | Wed May 21 00:57:33 EDT 2008 | stanyserrao
Hi, You can set up the factory in Hassan In India in KIDC near to ISRO. Labor Cost operator 60$ per month. Tax is defends on Govenment. Thanks Stany
Electronics Forum | Tue Apr 09 22:19:38 EDT 2019 | d_nguyen2018
Thank you, Alex!
Electronics Forum | Tue Apr 09 21:57:42 EDT 2019 | alexvolovich
If you were able to do a first/last part, then your tray wagon is set-up. You need to go to Tray Types and program the tray that will match the piece of tape you have. Then you should be able to add your component to the tray wagon.
Electronics Forum | Thu Oct 08 12:02:15 EDT 1998 | Bernardo Mendoza
I need to set a cleanliness limit for our incoming boards. I know that some people use 14-10 microgr. sq. in. But how can I determine what is best for me. Can anybody tell me if there's a standard for this. Right now we are using an Alpha Ionograph