Electronics Forum | Wed Jun 10 01:33:20 EDT 2015 | leeg
Are the leaf springs in good order and set right? If they are then it could be calibration related.
Electronics Forum | Tue Jun 05 02:10:01 EDT 2018 | buckcho
Hello sir, Limits in SPI can vary a lot, also depending on finishing of the pcb. For example 170% volume on an IC (assuming is fine pitch) can be okay for ENIG, but very bad if HASL. For are I would recommend that you use either 50-130, or 60-135 max
Electronics Forum | Wed Jun 06 06:16:49 EDT 2018 | jacson_vu
Thank for your sharing. I am also trying find out the best parameter for our product.
Electronics Forum | Mon May 03 17:23:24 EDT 1999 | Kelly Morris
I am about to embark on an effort to evaluate 3 different solder material suppliers and their recommended materials for our assembly process, in an effort to find the best supplier/material. We do mixed technology, with NOCLEAN chemistry so I will b
Electronics Forum | Wed Feb 12 14:33:09 EST 2003 | Ehess
We are in the process of settign up an SMT line with conveyors. When planning for a 4ft conveyor (or 2 or 3ft for that matter), how mush space should I set aside for this? My boss is telling me to leave 4'6" for a 4ft conveyor. I think this is too
Electronics Forum | Wed Feb 12 16:20:01 EST 2003 | vortex
4'2'' should be enough, going any higher and your bound for large gaps between machine and conveyor. Its been awhile since I set any up but i'm sure that 4'2 will be enough but not too much. I'm sure I wrote down my exact measurments, if I come acros
Electronics Forum | Tue May 04 10:30:35 EDT 1999 | Dave F
| I am about to embark on an effort to evaluate 3 different solder material suppliers and their recommended materials for our assembly process, in an effort to find the best supplier/material. We do mixed technology, with NOCLEAN chemistry so I will
Electronics Forum | Wed Aug 04 14:23:06 EDT 1999 | Dave F
| Jim McCarten and Dave F, | | Jim - How about a little explanation on your PlacePro 7100 comments? I'd like to know what a "typical SMT board" is and how "thruput is cut in half" by assembling it. Is this typical SMT board something that most manuf
Electronics Forum | Tue May 04 14:42:58 EDT 1999 | Chrys Shea
| | I am about to embark on an effort to evaluate 3 different solder material suppliers and their recommended materials for our assembly process, in an effort to find the best supplier/material. We do mixed technology, with NOCLEAN chemistry so I wi
Electronics Forum | Mon May 10 07:53:48 EDT 1999 | Timothy O'Neill
| | | I am about to embark on an effort to evaluate 3 different solder material suppliers and their recommended materials for our assembly process, in an effort to find the best supplier/material. We do mixed technology, with NOCLEAN chemistry so I
