Electronics Forum | Thu Oct 20 13:34:08 EDT 2011 | babe7362000
I checked the housing and it can move up and down freely. I went into Cal and also moved it without a problem. The sensors in the digital I/O seem to be fine. I checked the voltage going to the driver card and it seems to be fine. I think I will s
Electronics Forum | Thu Mar 06 17:27:17 EST 2014 | bobpan
Does this happen with just 1 gantry? If so...I would think your encoder in that gantry/axis needs cleaned. I have seen digital i/o cards cause this issue. But usually you will notice this when opening and closing the doors. The head would sometimes
Electronics Forum | Sun May 11 17:29:17 EDT 2014 | bobpan
Most times when the machine oscillates when closing the doors it will be a problem with the digital i/o cards. I would check that the dip switch settings are correct. If they are correct i would look at replacing both of the cards. The boards are sub
Electronics Forum | Tue Nov 02 03:39:09 EST 1999 | cklau
FABmaster gold version can read many kinds of CAD data i.e Zuken CADSTAR , PADS ,Mentor Graphics, Cadence and etc and the best place that could find great information for manufacturing is thru the CAD data.FABmaster actually act as a multiple i/o for
Electronics Forum | Thu Jul 13 22:20:38 EDT 2000 | Dave F
=10 mils larger than lead 3 silk screen legend text weight >=10 mils 4 pads >=15 mils larger than finished hole sizes 5 place through hole components on 50 mil grid 6 no silk screen legend text over vias (if vias not solder masked) or holes 7 so
1 |