Electronics Forum | Wed Jan 02 10:20:10 EST 2019 | jdengler
Sorry, I looked at an IP-3 not 2. It looks like for the IP2 they bundle the MTU and machine proper together so it should be sending the data when you transmit the one file. Do the axis travel in the correct direction? If yes the only thing I can
Electronics Forum | Mon May 02 21:26:23 EDT 2022 | rob1
I have a problem with DEK 265 Horizon. During camera being homed after checking the fiducials, the camera failed to home properly and crashed into the back of the machine in the Y direction. I homed the camera in the Y and it appeared OK and I could
Electronics Forum | Tue Mar 07 12:19:18 EST 2000 | Bill
Hi, John, Aerofeed Inc. is listed in Smtnet's Industry Directory as a manufacturer of nitrogen storage (desiccator) cabinets. You might try contacting them. They've got literature available to email you directly if you're interested. Bill
Electronics Forum | Mon Feb 28 21:06:39 EST 2000 | Pat Copeland
Can anyone direct me to a proper footprint for an s-mini 2 pin diode. I can not find one in the manufactureres data sheet and this part is not in the IPC book. Anyone know where I can find it.
Electronics Forum | Mon Feb 28 21:13:53 EST 2000 | Pat Copeland
Type in the part number at digikey.com parts search. Leave out the PEC and you will find three parts. One will direct you to the General Semiconductor site. This should help
Electronics Forum | Mon Feb 14 11:59:50 EST 2000 | Charlie
If you would be so kind, I need some fundimental data for several sources. The question is, 'What is your SMT yeild directly after reflow?'
Electronics Forum | Wed Dec 13 13:42:57 EST 2000 | Mike Ihm
The dielectic absorption characteristic of printed circuit board materials is usually not listed on the manufacturers spec. sheets. Can anyone point me in a direction to help determine which laminate materials might exhibit better dielectric absorpt
Electronics Forum | Thu Nov 30 11:10:36 EST 2000 | DL
Can anyone point me in the direction of where to find some lead placement equipment. Currently we have Clip leads that come in reels with solder pre attached are currently done by hand. surface mountable leads/connectors will not do, due to board/end
Electronics Forum | Sat Oct 28 10:24:56 EDT 2000 | Ben
Try to insert thin copper plate (approx. 1.5mm thk) at the end of the flow direction. Place it approx. 2mm away from the lead. The copper will pull away the solder & thus minimise bridging problem.
Electronics Forum | Fri Oct 13 15:05:02 EDT 2000 | Robert Russell
Just wondering about what happen to "Noakes Electronic Equipment". I have them in my notes as a Refurbisher Company. There phone numbers no longer exist and I can't find them on any search engin. Just looking for a kick in the right direction.
