Electronics Forum | Thu Nov 05 10:09:36 EST 2009 | soudomphong
Hi guys, I am looking for a processor board for econopak plus wave solder. Teknor microsystems (TEK234). Please email me if you have or know who has it. Thanks.
Electronics Forum | Wed Dec 21 06:51:48 EST 2005 | aj
Hi all, I have an Electrovert Econopak Plus wave solder machine. Lately the solder pot temp has been fluctuating +/-10 degrees c. I have replaced the thermocouple as I suspected it to be faulty but the problem still exists. I am confident that the
Electronics Forum | Mon Dec 12 13:34:15 EST 2005 | jbrower
Hi Frank I use an electrovert econopak and am very pleased with it. Electrovert offers a leadfree upgrade to the pot but it is a might bit expensive. Contact them for pricing. In my machine I am going with SN100 distributed by AIM. It might be some
Electronics Forum | Mon May 15 08:53:52 EDT 2006 | aj
Hi All, Due to carry out the Bath Changeover this weekend. I have an Electrovert Econopak- 550 kg bath. We are not replacing our internal components i.e nozzles/pumps etc. until we really have to. Has anyine carried out there changeover yet and ha
Electronics Forum | Wed May 19 15:23:07 EDT 1999 | Justin Medernach
Hi All, I'm getting an Electrovert Wave. It's the replacement for the Econopak. I can't remember the name. Either way, the spray fluxer is made by USI. Does anyone have experience with this spray fluxer. Good or bad would be appreciated. Thanks
Electronics Forum | Tue Oct 12 20:19:38 EDT 1999 | Eric Chua
| Hi All; | | I have heard there is a software to make MCS16F Y2K-OK. Has anyone heard if this is correct? If so, from where and how much? | | Thanks for your time; | Hi Carl, Yes, is correct. There is software for the MCS16f Y2K. I had
Electronics Forum | Tue Oct 12 20:22:04 EDT 1999 | Eric
| | Hi All; | | | | I have heard there is a software to make MCS16F Y2K-OK. Has anyone heard if this is correct? If so, from where and how much? | | | | Thanks for your time; | | | | | Hi Carl, | | Yes, is correct. There is software for t
Electronics Forum | Wed Jul 10 22:13:45 EDT 2019 | SMTA-Ray
I don't recall if the heater wattage is the same or not for the different pots. If the wattage is different then the PID algorithm is also different. this anticipated when & by how much the heater will overshoot its setpoint and turns the heater off
Electronics Forum | Mon Oct 11 12:44:30 EDT 1999 | carl
Hi All; I have heard there is a software to make MCS16F Y2K-OK. Has anyone heard if this is correct? If so, from where and how much? Thanks for your time;
Electronics Forum | Tue Dec 09 18:25:09 EST 1997 | Kevin Searfoss
We are looking for spare hard drives for the Fuji MCS computer. I believe this is an MFM drive. Is this correct? Where can these drives be found? Thanks.
