Electronics Forum | Fri Oct 12 09:00:31 EDT 2007 | vargas_s
We've been using a series of relatively high durometer rubber molds to protect male headers from conformal coating here in our facility for quite a while now. They are black in color and are sold in strips that can be cut to desired lengths. Unfortun
Electronics Forum | Fri Oct 12 15:31:28 EDT 2007 | wayne123
I am needing to know if anybody uses a Reflow oven Chain oil that doesn't create a horrible smell. Whenever we put this oil on it burns off and smells like I am stuck at a stop light behind a car with bad rings. I have looked at several oils that adv
Electronics Forum | Fri Oct 12 16:29:21 EDT 2007 | dyoungquist
When we bought our Heller reflow oven, the installation technician recommended using Oberon chain lube part # 680784(0) when we needed to purchase more oil for our chain. I just went to the oberonlube.com website and could not find that part number.
Electronics Forum | Tue Oct 16 06:41:22 EDT 2007 | aj
Hi All, I understand that reflow Profiles are Product dependant but I would like to compare my profiles to what others are doing. Any input is greatly appreciated. I have a 5 zone Oven + 2 cooling Zones. ( Leadfree) If I could get some answers to
Electronics Forum | Tue Oct 16 08:09:39 EDT 2007 | davef
In the fine SMTnet Archives, grantp gave the following response to a similar question: KIC supplies a free-downloadable software that "takes your profile data and recommends the best oven temperature settings and conveyer speed for your oven. The so
Electronics Forum | Tue Oct 16 12:34:40 EDT 2007 | actech
I have a V III that has a bad "Y" axis Bearing, it is different from the CSM 84 /V/VZ machines "It has dual bearing races on each side", Anybody have one for sale or a part number Philips list the machine as an "END OF LIFE" machine and support is li
Electronics Forum | Wed Oct 17 21:33:16 EDT 2007 | davef
What service company do you use for the sharpening of dykes, side cutters, diagonal cutters? What process controls do you suggest in maintaining good process from such a service company? While we're on the topic, we have aways used semi-flush cutte
Electronics Forum | Thu Oct 18 18:37:59 EDT 2007 | mefloump
Hello all, I was wondering if anyone knew of a stateside distributer for Yaskawa? I am looking for a VS-606V7 200V single phase, .55kW, model #CIMR-V7CCB0P4, in case you happen to have one laying around. It is for a Soltec Vitronics Selective Solde
Electronics Forum | Fri Oct 19 10:49:48 EDT 2007 | brulal1
Hi I will like to know what do you think about cleaning hand solder, my employee spend about 25% of they time to brush they hand solder with teddy pen cleaner, we used no clean solder wire. It�s not been the first time that I try to eliminate those c
Electronics Forum | Fri Oct 19 16:24:53 EDT 2007 | jmelson
Really, if you start out from the beginning planning to clean the boards, then DON'T use the no-clean flux! The way that stuff is made, it leaves a hard, low-solubility residue that takes a LOT of effort to get clean. If you plan to clean, use a wa
Nordson Electronics Solutions makes reliable electronics an everyday reality. Our ASYMTEK, MARCH, and SELECT brands deliver precision fluid dispensing, conformal coating, plasma treatment and selective soldering equipment.
2747 Loker Ave West
Carlsbad, CA USA
Phone: 18002796835