Electronics Forum | Wed May 20 05:50:08 EDT 2020 | tima
Hello colleagues, Question. Who ever done 4 mil (100uM) electro conductive epoxy dispensing? is it even possible? I did 6 mil but very unstable results... Now I need 4 mil for an application.
Electronics Forum | Thu Jun 25 10:56:48 EDT 2020 | kumarb
Hi. Contact PVA in the US. Our company has been a supplier to them for many years to date for the adapters used in their machines. This is their vertical. Hope this helps.
Electronics Forum | Wed Dec 17 13:34:15 EST 2008 | jorge_quijano
Ok, thanks for the info, fortunatelly we already have our Camalot glue dispenser machine In-line with our MPM, for helping whit the high stand-off components.
Electronics Forum | Fri May 18 12:21:28 EDT 2001 | camohn
When it comes to how much epoxy [aka. "glue"] to dispense to hold a IC or any part with significant mass, on the bottom of a board for wave soldering, is more better? The way I see it, one good dot should be holding such a part on the PCB. If not, th
Electronics Forum | Mon May 21 17:34:22 EDT 2001 | davef
Continuing the line of Michael's, the previous poster, comments ... The more Krispy Kremes, the better. Yeth!!! The more beer, the better. Yeth!!! The more epoxy, the better. Uh, I don think so!!! We look at this from a papa bear, mama bear, bab
Electronics Forum | Thu Aug 06 12:49:41 EDT 1998 | justin medernach
| I am looking for advice or information from anyone about the possible reliability problems associated with epoxy on solder pads of discrete devices. Will the epoxy expand and lift over time, Will there be adverse reaction between the solder and the
Electronics Forum | Thu Oct 07 09:59:01 EDT 1999 | Dave F
| I recently had the opportunity to visit the vendor who is making my boards. On my trip I noticed that the guy who was in charge of the SMD placement machine (brand new Samsung) still had to manuallly place about 20%-40% of the parts after placement
Electronics Forum | Fri Aug 07 01:02:51 EDT 1998 | zeek - just wanna to get a word in here
| | I am looking for advice or information from anyone about the possible reliability problems associated with epoxy on solder pads of discrete devices. Will the epoxy expand and lift over time, Will there be adverse reaction between the solder and t
Electronics Forum | Fri Feb 03 15:39:01 EST 2017 | ttheis
Thanks, we'll try this too. We aquired an asymtek millenium for dispensing selectively. It is setup for epoxies with a needle dispense head so we'll try to make it all work for us. One-part silicones seem to be the popular solution.
Electronics Forum | Tue Jan 31 12:19:29 EST 2017 | ttheis
We're looking to add conformal coating to some of our pcb's which range from 2x2" to around 6x6". I would like to use a coating material that is not nasty smelling requiring ventilation or filtration if possible. Are there conformal materials that ar
