Electronics Forum | Tue Apr 17 15:28:35 EDT 2007 | electronhose
I've used both GPD and Hepco formers. The Hepco radial former is this one: http://www.hepcoblue.com/1800.htm The GPD radial former is this one: http://www.gpd-global.com/text/product/cf9.htm The GPD offers more custom die sets and variations th
Electronics Forum | Fri Dec 15 09:25:44 EST 2006 | russ
unfortunately you need to increase your maintenance on these ovens, I would doubt if anything is wrong with your equipment. the Flux accumulation is normal, and you are putting alot of flux through those ovens. Just clean more often Russ
Electronics Forum | Thu Jan 23 18:34:15 EST 2020 | slthomas
It's hard to poka-yoke loading reels onto the machine (either a inserter-sequencer or a sequencer, then getting the sequenced reels properly indexed). The only way I know of to make sure they've been set up properly is with visual inspection of EVERY
Electronics Forum | Sun Jun 14 15:40:48 EDT 2015 | csm
Dear All We are looking some Phillips Technician can do programming for FCM-2 equipment and we are looking the Programming manuals and maintenance manuals. Can somebody help us, or can give us support to give maintenance and programming to some FCM
Electronics Forum | Tue Dec 23 11:06:00 EST 2003 | ex maintain leader
I'm agree with suggestion "ceaning importance" you schould make your leader job in three group of maintenace the equipment 1st daily maintenance line operator is responsieble to lean the machine on the surface where is not need any tools required
Electronics Forum | Thu Dec 28 08:10:13 EST 2023 | vickey
Always follow the manufacturer's guidelines and recommendations when troubleshooting or performing maintenance on the equipment. If you're unsure about any step, it's advisable to seek assistance from Fuji's technical support or a qualified service t
Electronics Forum | Tue Mar 31 22:35:10 EDT 2009 | davef
Joe We agree with you. BUT why not ask your safety guy for support from an industrial hygienist? We get them to come by once a year and do an audit. It maybe that you should use the same gear as you used with leaded process equipment maintenance [e
Electronics Forum | Mon Mar 23 13:21:32 EDT 2009 | joeherz
We have recently installed a selective solder machine that is running SN100C alloy. Based on the fact that the pot maintenance is done inside the equipment where adequate ventilation is present and we aren't dealing with lead, I don't see the need f
Electronics Forum | Fri Jan 27 16:58:24 EST 2006 | solderman
Hi Ams, I often cringe when I read replys like the ones you got. I will give 'chris' the benefit of the doubt in that he is sincere in his response. However, there are people posting here with agendas to sell specific equipment. Without knowing
Electronics Forum | Fri Mar 16 11:52:31 EST 2001 | J.D. of Panasonic
Ed, You certainly are ready for some equipment. I noticed in your message that you mentioned cost three times. So it is a very big issue to you. What everything depends on is where you see your company going in the next few years. Do you want
