Electronics Forum | Mon Sep 17 18:12:54 EDT 2007 | sarason
Then look for a disconnected supply or earth to the head. A dodgy cap (high ESR) on the supply of the board. Put a CRO on the supply and check it's supply and earth to chassis and to each other and then compare the level to other boards in the machin
Electronics Forum | Wed Mar 05 02:59:00 EST 2003 | MA/NY DDave
Hi I was poking around for awhile and gave up on time. With a little more I could probably find a good article. Yet here is an article that tells you a little about decoupling capacitors although really more focussed on higher values. I thought abo
Electronics Forum | Sat Mar 05 22:32:58 EST 2005 | gpaelmo
Yes we've had problems with kemet caps on 12mm t/r. By the time it gets replaced, our production schedule gets so screwed up. Our immediate solution was to bypass and place them by hand before reflow. We eventually went with a cross from Venkel and i
Electronics Forum | Sat May 09 11:01:59 EDT 2015 | alphatronique
Hi few year back i design a board for a customer then build pre-production run on my in house line ,all was good then the customer for going into production what to save few $ move to my competitor for assembly this was in late fall then in summe
Electronics Forum | Fri Mar 04 15:39:29 EST 2005 | russ
Anybody out there using these and having trouble getting them out of the tape? We currently are experiencing these parts being stuck in the tape. The carrier tape is mis-formed leaving a slight lip over the top of the component preventing our place
Electronics Forum | Thu Sep 15 13:55:31 EDT 2022 | jojoled
Hi all, I need help with problem Iam stuck with JUKI KE760L. -SERVO ALARM 1 and ALARM4 https://photos.app.goo.gl/CCDcNtbbEhJLBo47A Sometimes I do get error ON ALL 4 SERVO drivers (1-2seconds after starting the calibration routine (even before the Z
Electronics Forum | Wed Apr 18 08:14:20 EDT 2007 | davef
Silver palladium termination * AgPd-terminated capacitors are designed for conductive adhesion. Reflow or wave soldering is not recommended. [EPCOS Multilayer ceramic capacitors, Soldering directions, October 2006] * CONDUCTIVE EPOXY BONDING. Epoxy c
| 1 |
