Electronics Forum | Tue Jan 21 13:43:12 EST 2014 | rgduval
Jorge, Your description of the process sounds about right. A fixture to hold the flex cable taut (and in a repeatable location) that allows you to paste/place/reflow is essential. As for notes: Be hyper aware of moisture/humidity in regards to
Electronics Forum | Fri Nov 30 05:28:12 EST 2012 | d0min0
Hello, we are starting with the flex pcb production, can anyone advice a company in europe that is capable of design and manufacture palett / carriers / frames that allow to produce flex boards in standard smt process regards
Electronics Forum | Mon Mar 10 14:03:18 EDT 2008 | swag
Has anyone ever used local fids on flex circuits that are applied by the board house as black ink dots? Good or bad experience? We have a flex board that has two identical 60 pin, fine pitch connectors on it. From limited experience and reading so
Electronics Forum | Thu May 29 10:42:40 EDT 2003 | swagner
So is it fair to say that on a moisture laden double sided flex circuit you could see an increase in tombstoning on the 2nd pass due to warpage created by delamination? In other words a 0603 for instance could tombstone due to the delaminated surfac
Electronics Forum | Wed Mar 16 09:48:44 EST 2005 | jdengler
I'm with Russ on this one. Had a similar problem with a flex circuit that used gold contacts into a ZIF connector on a ridged PCB. After may test I finally convinced the customer to do some test on the ZIF connector. The end result was flux contam
Electronics Forum | Thu Jun 09 10:41:30 EDT 2005 | HOSS
Can anyone recommend a flex/rigid-flex supplier stateside that can do the following: Build to IPC class III (not necessarily certify) Multi-layer Controlled Impedance 2-4 week turn without price premium Take less than 1 week to quote Any info appre
Electronics Forum | Wed Jul 16 00:15:38 EDT 2003 | iman
just out of curiousity, why the special nitrogen cabinet concerns for gold plated flex PCB? common "myth/fact" is gold is an "inert" coating layer that is not going to react with room environment conditions *that much?*. Am learning here, so would ap
Electronics Forum | Thu May 29 10:05:10 EDT 2003 | swagner
I hate to answer a question with a question but what are the particular effects of moisture absorption in a flex circuit?
Electronics Forum | Wed Sep 29 12:17:03 EDT 2010 | swag
You might try assembly carrier tape such as Tacsil on your fixtures. Beware - arrays are very diffult to run in SMT flex unless you have no fine pitch.
Electronics Forum | Fri Oct 01 09:47:36 EDT 2010 | noid
Yes, they should be baked prior. We pre-bake all polyimide fabs, flex or not. They are prone to delam.
Midwest Circuit Technology provides Carbide Router Bits and End Milling Cuters for use in PCB Depaneling equipment. We have over 35 years of supplying tools and machining experience in drilling, Routing, Test Fixture manufacture.
114 Barrington Town Square
Aurora, OH USA
Phone: 13309956900