86 flooded results

Electronics Forum: flooded (Page 2 of 9)

Angle of board on wave

Electronics Forum | Fri Jan 21 11:15:28 EST 2005 | russ

Are you running any type of vibratory wave on the Vitronics as opposed to the electrovert? How about any turbulent wave differences if any? The only time I have ever flooded boards in fixtures is when the seal is broken or run an excess amount of v

Wave Solder Non wetting holes

Electronics Forum | Thu May 19 12:50:19 EDT 2005 | splice1

Hi Hoss, Thanks for your reply. Yes I am seeing the flux flood over to the top surface of my board, so to an extent I am not concerned with the fluxer. I believ that the foam fluxer is functioning adequately.

via tenting and pluging

Electronics Forum | Fri Nov 03 07:28:27 EST 2006 | davef

Via filling methods are: * Tenting * Plugging * Capping * Flooding Tented Via. A via covered with dry film soldermask; the via is not filled. When tenting from both sides there may be issues with trapped air that expands during mass soldering. Plug

Austin American model9700 board cleaner

Electronics Forum | Tue Apr 03 09:42:05 EDT 2007 | oster

We currently have two 9700 Emulsonator board cleaners, would like to chat with others who are having problems with flooding, controller problems and have done the controller upgrade. Thanks

wave soldering and solder bridge

Electronics Forum | Mon Dec 17 14:16:44 EST 2007 | realchunks

This is funny. Poeple giving answers to a question that isn't specific. What if the shorts he is having are on the top of his board, caused by flooding or Omega wave too high?

Printer

Electronics Forum | Fri Jun 20 14:41:08 EDT 2008 | mmjm_1099

I second that with the used market. They are flooded with machines out there just look for the best deal and make sure your covered under a warranty.

Thick Film Screen Printer

Electronics Forum | Fri Aug 12 17:12:24 EDT 2016 | hshorakaei

Thank you for response. But I don't know the difference between stencil and screen printer. I also don't know what is flood print mode. Can you kindly explain what are these?

Reducing Warp after reflow

Electronics Forum | Thu Oct 13 21:43:47 EDT 2022 | sarason

If you are running resonable volumes of the board, redesign it with equal copper on both sides. One way of achieving this is to just run copper flood planes on both sides of the board, this is a fairly common technique in RF and noise sensitive analo