Electronics Forum | Thu Aug 31 19:40:22 EDT 2006 | cardinal
A couple things on the Grid-Lok system. They now offer a top-side edge clamping system. The edge clamping system works very well for warped, twisted boards etc.. Using this system in the auto mode also allows the pins to contour to the geography of
Electronics Forum | Thu Aug 31 21:43:13 EDT 2006 | fastek
I don't sell them for $25K either but my point is they can be had for that price. In fact the last (2) that I had I purchased for $8K and $9K. I never have claimed to be the cheapest dealer around and it's not my intention......I only intend to be
Electronics Forum | Fri Sep 01 01:18:37 EDT 2006 | cardinal
How many of these printers have sold in the last three years? I have sold over 40 in the last 18 months. You can claim all the numbers you want. If you have the units to sell at $25K; then sell them. If you are selling them at $25K, you are selling
Electronics Forum | Tue Sep 05 16:26:53 EDT 2006 | Bill
Thinking about this auto-mode on Grid-Lok..... Ok, the board is warped, lets say positively, the pins conform to the warped board... what about the effect on top side and squeegee pressure? It will be much higher and could damage stencils, right? Pos
Electronics Forum | Thu Sep 07 09:04:24 EDT 2006 | Doug Eidle
Hi, First off, I am the Pre Owned Equip. Business Mgr. for Speedline Technologies. We have a factory Renewed (our enhanced refurbishment process) available. You can contact your local Speedline MPM Rep for price and information. If board warp is
Electronics Forum | Fri Sep 08 16:12:38 EDT 2006 | Buzz
NO! We need to try to initiate the description of the criteria for requirements by developing a framework for the application architecture consistent with the planning corridor specified in our strategic initiative. Once bilateral goals are establi
Electronics Forum | Mon Aug 28 12:44:23 EDT 2006 | actech
WE have been running a leaded product for a few years and while the product is exempt from PB free regulations the components have been comming in lead free reciently and this caused little or no change in the process and or product, However! the Boa
Electronics Forum | Tue Aug 29 17:36:39 EDT 2006 | aj
Hi Bruce, We are a CM aswell and I can sympathise with your situation but you will have to advise the customer that you have issues with this board finish and recommend an alternative. If they are exempt why are they supplying you with Leadfree Boar
Electronics Forum | Mon Aug 28 17:02:07 EDT 2006 | SWAG
We are constantly messing around with easy ways to transport double sided boards through reflow. (Boards that cannot ride on the chain fingers for any number of reasons). We've got some fancy Durostone carriers that work awesome but are product spe
Electronics Forum | Tue Aug 29 07:40:20 EDT 2006 | CL
Good Morning SWAG, We have the same situation. We have found that for the most part, bottomside components do not move from thier location durring reflow unless pressure is applied. We have had instances where the component is able to drop down into
