99 fuji cp6 8x4mm feeder results

Electronics Forum: fuji cp6 8x4mm feeder (Page 9 of 10)

Re: Fuji holders seizing up

Electronics Forum | Sun Mar 21 22:03:35 EST 1999 | Nick

It looks like your holders now require some maintenance. You will need to throughly clean all the holders of all dirt debris and then relube the holder lightly with T&D or grease. You will only need to lube the shaft of the nozzle change enagager an

Re: Hi-Speed SMT manufacturing

Electronics Forum | Wed Feb 17 22:55:25 EST 1999 | Dave Kalen

| | SMT Mfg. Equipment: Fuji CP-6/IP-3 - but please all hi-speed chip placer users input are appreciated !! | | | | The company that I work for is a C/M which offers both consignment but mostly turnkey work. I am currently running 3 Fuji lines. All

4790 replacement

Electronics Forum | Mon Jan 22 13:02:10 EST 2007 | shap

We are looking at replacing our aging 4790 for something. We are replacing our GSM1 with an Advantis. We are a prototype shop and do runs of 5 to 30 normally and once in a while a run of 300. So we are looking for flexibility and ease of set up.

SMT EQUIPMENT FOR LOW VOLUME HIGH MIX

Electronics Forum | Mon Apr 28 11:52:28 EDT 2003 | hruiz

Thanks for your responses, as gregp says, one hour in changeover is not good when you run only 10 panels, we alredy do from 10 panels to 2500 boards per run, depends on the product, we already have a pre-kitted area mounted in their respective feeder

Fuji CP6 Feeder Problems

Electronics Forum | Thu Jun 24 07:22:19 EDT 2004 | cyber_wolf

I know I have posed this question before, but I would like to open this discussion again. We do several change overs through the course of three shifts on our CP642 line. When we start a new job, we have tons of tape feeder overlay problems.(The over

Fuji Pick and Place Machines

Electronics Forum | Thu Jun 10 16:23:11 EDT 2004 | davem

Hi Grant, In previous positions I've had experience with the Fuji CP43, CP6, CP642, CP643, CP65, IP3 & QP242. In operating, training and process engineering capacities. Presently, I'm working with 2 SMT lines (in a process engineering capacity) wit

Fuji CP-6 Feeder Maintenance Programs

Electronics Forum | Fri Oct 26 02:12:35 EDT 2007 | jola

Hello. In a stupid way I'm glad not to be alone in the feeder jungle. We have the same ammount of feeders with a mix of Fuji and Panasonic high spped feeders as the main problem. The way we do it at the moment is that we have marked up all with a num

Re: Hi-Speed SMT manufacturing

Electronics Forum | Sun Jan 31 14:34:50 EST 1999 | Dean

| SMT Mfg. Equipment: Fuji CP-6/IP-3 - but please all hi-speed chip placer users input are appreciated !! | | The company that I work for is a C/M which offers both consignment but mostly turnkey work. I am currently running 3 Fuji lines. All parts