Electronics Forum | Sun Oct 02 10:40:10 EDT 2022 | omar08
Hi, I have this problem in NXT3 fuji machine . 80001919 vacuum break completion error. 88D40000 Placement (part rejection ) error
Electronics Forum | Tue Oct 01 05:10:20 EDT 2013 | anilw2006
Please go to output from I/O option and press on/off option in the main conveyor. While on condition motor should on when off motor should stop.If this will not happen then need to change I/o card.
Electronics Forum | Sat Sep 28 15:58:38 EDT 2013 | sonavc
Hi. 'm new to this Fuji CP3, I bought this machine in working condition ( I saw it ran, but I forgot to check the board in and out ).... Moved to my location, Problem: When the board is trying to load to the X-Y table, it passed the conveyor B but
Electronics Forum | Wed Oct 02 00:35:33 EDT 2013 | sonavc
thanks I tested the conveyor A or B , when it is on the motor turn and the green LED at the out put card is also light on. But when i turn on the X y table motor , the green LED is on , but the motor is not run. I will try to replace the I/O
Electronics Forum | Wed Oct 02 07:43:21 EDT 2013 | aj
could be a faulty motor? you can check the voltage at the connection to the motor when the IO is on.....or swap the motor.
Electronics Forum | Tue Mar 16 17:34:27 EDT 2021 | dan_ems
Hello, can you help please with a question regarding Fuji NXT programming? During the placement of the components on the fuji interface the image of the components during alignement can be seen on the Fuji operator interface. My question is can be al
Electronics Forum | Sun Oct 09 13:16:13 EDT 2022 | acouto
yes, they have already been tested with different heads and the error persists.
Electronics Forum | Wed Apr 17 13:48:32 EDT 2024 | jdengler
I have a AIMEX III and we have seen the top cover on the conveyor being pushed out of postion when someone does maintenance. I beleive the NXT's use the same configuration. Check to see that the cover is pushed all the way over where the PCB would
Electronics Forum | Wed May 07 09:53:54 EDT 2008 | llaerum
We have had some trouble with our Jot conveyors and the FUJI NXT. We had to modify the JOT control circuit in order for the SMEMA protocol to work prpoerly. I am not saying that this is JOTs fault. There seemed to be an incompatibility and modifying
Electronics Forum | Thu Feb 02 20:48:07 EST 2006 | ____
I would like to start a new post regarding fuji > NXT machine. What do you think about the machine > as far as the servicing of the machine goes. I am > so used to the older machines such as : CP,IP, > and QP. Those machines at least give you som
