Electronics Forum | Thu Apr 12 15:21:12 EDT 2012 | jdengler
Have you tried to do a reset start? When Fuji's act weird the first place to start is a reset start, then re-load the Proper Status and Program. Jerry
Electronics Forum | Thu Apr 12 17:49:35 EDT 2012 | rodrigo
I've done the Fuji flush. It does the same thing. We can not load proper again because it does not communicate with either the F4G or MCS/30. I was able to boot into mechanical mode at one point but now I can not do that either. This thing is drivi
Electronics Forum | Wed Dec 11 09:36:18 EST 2024 | introlab
In the main menu, press the SW version icon, then type ilovesafety and the top blue line will start blinking, select the close button. Press the software setting icon, now you can use the operator setting icon to change /recover password.
Electronics Forum | Mon Apr 16 10:48:58 EDT 2012 | cyber_wolf
Sounds like a bad or out of adjustment servo amp.....
Electronics Forum | Wed Apr 11 17:00:28 EDT 2012 | rodrigo
Hi all, Our cp4 moves rather violently (jerks) all axis when the reset sw is pressed after power up. I've got all sorts of errors after boot up: Servo amp error: D,X,Y, etc Overtravel D,X,Y, etc D clutch error, power off machine We've checked all
Electronics Forum | Tue Apr 17 13:07:17 EDT 2012 | rodrigo
Well... after much headache I found a bad relay contact in M1CR1E. The good news is somehow the axis are no longer jerking. The bad news is that it still does not work. When I turn it on now it shows this: emergency stop (in red) waiting for reset
Electronics Forum | Mon Apr 16 13:31:36 EDT 2012 | jdengler
Have you tried to restart F4G and/or MCS/30 after flushing the CP4 memory? I have occasionally ran into the comm error after a reset start. Leave the machine on and restart F4G or the MCS/30 whichever normally is hooked up. If it still won't commu
Electronics Forum | Fri Jan 17 11:21:45 EST 2014 | mi
Hi, Flexa is a NEW SW TOOL that Surya purchased for SMT assembly. (Surya has had experience with GC-PLACE but limited only for Mydata machines SMT placement.) Flexa is good for Fuji machine. My question was configuring this SW TOOL's connection set
Electronics Forum | Fri May 01 00:27:12 EDT 2009 | rodrigo
Hi all, We had a servo amp replaced (SA-6) and the machine worked with no problem for the first panel (this panel of 10 only needs a TQFP100 from the MTU). Then I got the "Servo NG" error again. One of the servo paks showed a "7" on the LED. The err
Electronics Forum | Fri Aug 28 12:46:04 EDT 2020 | inspiredmorris20
Greetings all, my cp45 pnp machine is down this morning, gives me the code 0002 (front EME switch pressed). operator said they did not E-Stop, reset the unit and reboot the S/W a few times. the code pops up as soon as the software loads. I can turn
winsouce.jpg)