Electronics Forum | Mon Feb 04 11:39:51 EST 2019 | robl
No worries. From memory you could get 2 types of head - 1 where you had grippers and the other where the head held the whole panel. We had interchangeable grippers. Also had some Cencorp 1000 & 1300BRs which were ok, but not sure on Global support
Electronics Forum | Thu Feb 08 03:01:22 EST 2018 | roblackey
Thanks Capse. Is Asys planning on adding grippers to it's Divisio laser range?
Electronics Forum | Sun Jul 26 06:13:02 EDT 1998 | Amr Sokkary
Dear Sirs, Please i need to know some contact fone numbers and faxes and contact persons to the following issues : 1. gripper pin for PCB assembly 2. Eyelets for PCB assembly 3. Pin connectors for PCB assembly 4. Sequebcer Bandoliery tape for axi
Electronics Forum | Wed Jul 29 20:11:28 EDT 1998 | Dave F
| Dear Sirs, | Please i need to know some contact fone numbers and faxes and contact persons to the following issues : | 1. gripper pin for PCB assembly | 2. Eyelets for PCB assembly | 3. Pin connectors for PCB assembly | 4. Sequebcer Bandoliery
Electronics Forum | Wed Jul 29 20:10:47 EDT 1998 | Dave F
| Dear Sirs, | Please i need to know some contact fone numbers and faxes and contact persons to the following issues : | 1. gripper pin for PCB assembly | 2. Eyelets for PCB assembly | 3. Pin connectors for PCB assembly | 4. Sequebcer Bandoliery
Electronics Forum | Wed Dec 17 09:04:19 EST 2003 | Kev
Not a europlacer user, but on our Philips Gem, we use a gripper nozzle for the upright molex conn. We found that using a standard vac nozzle negated both the speed of travel from feeder to PCB and the placement accuracy, as the connector moved on the
Electronics Forum | Mon Apr 18 06:17:58 EDT 2016 | smtsparescn
If there are too many components on the board and many components are standing near the board edge,to use a depaneling machine is a simple way,but a machine is needed, another possible way is to design and make a simple fixture,it holds the board fi
Electronics Forum | Wed Jun 05 15:15:37 EDT 2019 | cristian_amlima
Hi Guys.. greetings! I hope someone could help me. Does anyone knows how to configure a gripper nozzle to juki 700 series? (more specifically FS730). With this nozzle the machine should blow to inflate the nozzle and I don't know how to change from
Electronics Forum | Tue Dec 05 08:39:22 EST 2000 | sean o'keeffe
i have a Staubli RX90 Cr robot on the back end of a small production line for automated systest and i need to source jaw grippers....any ideas where to look....... any help appreciated
Electronics Forum | Tue May 16 21:25:23 EDT 2000 | Dave F
Alek & Ramon: What are we talking about: * Presentation: Feeders / trays / etc * Pick-up: Nozzels / grippers / etc * Reflowing paste for PTH parts Good luck Dave F
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
