Electronics Forum | Fri Dec 17 18:21:43 EST 1999 | Clarissa L. Ortner
We are a small start up. We will be buying a stenciling machine and semi automated pick and place. ( We have the oven) We are presently stenciling without any assit and loading leadless parts only(no fine pitch) by hand. We need to improve thrupu
Electronics Forum | Sun Oct 11 21:19:51 EDT 2009 | fulldrawmike
we have both flexjet and flexhead, we also have the new inline 7 head on some genesis dual beams we just put into operation. If you have a choice in flexjet heads take the inline 7. The flexjet 09 head is very labor intensive, stay away from them, e
Electronics Forum | Sat Nov 13 03:10:36 EST 2021 | pti88
why poor contact between PCBA board and probe？ When I used ICT to test PCBA board, there was poor contact between board and probe .
Electronics Forum | Tue Aug 28 09:53:44 EDT 2001 | Brock
Stefan, I could be wrong but I have a question about every 10th board having a defect. If a machine places 1 million components and a the board has 200 components you arrive at 5000 boards. If every 10th board has a defect, then only 500 boards have
Electronics Forum | Tue Sep 13 07:00:28 EDT 2016 | awhite
Thanks for the reply. When you hit start on the printer, you can see it send the "start cycle (SMEMA)" signal, and it immediately goes to "awaiting board from upstream." This tells me that the printer knows a signal has definitely been sent and rece
Electronics Forum | Fri Jul 28 14:34:13 EDT 2000 | Gary Simbulan
Belive it or not, these boards were run through a Centech batch mode Vapor Phase machine. Single stage top side IR preheat. Vapor temp 218 C. Solder paste is an SN62 RMA.The boards were FR4 8 layer w/ solder mask, fairly conventional as might be e
Electronics Forum | Wed Nov 17 20:11:29 EST 2021 | dwl
is there flux on the board? are you probing a test point or a soldered pad? is the probe hitting the right spot?
Electronics Forum | Mon Mar 26 09:41:03 EDT 2018 | fuji_user_2014
Hi Gurus, Looking for alternatives to line makeup after reflow oven. Currently, I have a continuous on flat belt conveying out of my reflow oven straight to an EOL bench. The operator manually picks up the board off the belt (there is a roller at t
Electronics Forum | Tue Mar 01 10:55:07 EST 2005 | spot
A lot depends on the complexity of the board/process as well as the amount of placements. If the board has few placements and the parts are not smaller that 0805 then doing all the rework after completion is ok. The human eye can only pick out obvi
Electronics Forum | Thu Jul 22 17:39:58 EDT 2021 | proceng1
We do use a company for custom fixtures, but we also make some in house. The biggest hurdle for a board that requires a fixture to go through printing and SMT is that the board has to be the tallest thing. So any hold downs or locating hardware has
