Electronics Forum | Thu Mar 24 23:34:55 EDT 2022 | glasscake
My Koh Young 3030VAL errors on the homing routine. The "DTool" "MCS" gives me an error "Before homing, X-AAxis already checked negative limit..." "Before Hoking, Y Axis already checked negative limit..." "Please turn off the control-power-switch, an
Electronics Forum | Thu Mar 30 08:04:56 EDT 2023 | hub
Hello, I'm looking for zevatech (juki) 570 owner that could help me to resolve my problem. I had the following error that occure just before (or sometime a few after) homing the machine : "E7018:Driver Error KNOCK position error ". Previsously I had
Electronics Forum | Wed Dec 14 11:55:52 EST 2022 | proceng1
I have 2 SM421s in service and they still support mine. What is the exact error message? Did you look up the code? What step in homing is it doing when it fails? Maybe post a photo of the error list or message that pops up?
Electronics Forum | Fri Dec 19 17:11:24 EST 2014 | guts1872
My QSP2 motors keep shutting off with an error message on the screen that says Z1 motion fail. Z safe motion motion failed due to previous error. When homing the heads I observe the servo amp indicator LEDs. They are all green while the gantries are
Electronics Forum | Sun Oct 18 11:48:50 EDT 2009 | Rul
Problems found are the machine frequent freeze suddenly and produce error message when homing the machine: servo devices failed ... Action taken. Change the pc with another working machine. result= same problem happen. check the fuse at circuit of t
Electronics Forum | Thu Mar 21 02:52:59 EDT 2019 | bukas
looks like home sensor problem, whats the error message? does head 6 now work properly?
Electronics Forum | Tue Sep 23 14:23:19 EDT 2008 | jeffjarmato
Exact Error Message: Following error on Z axis Happens during Homing the machine. Right now as Z Up
Electronics Forum | Thu Mar 01 19:23:41 EST 2007 | SWAG
I could be wrong but I think the use for alternate feeder axis is a way of stopping the carriage so it does not always return to home every time an error condition exist. Saves on time and wear and tear on the machine. As for alternate carriage, I
Electronics Forum | Sun Apr 17 18:22:18 EDT 2022 | dekhead
Please clarify what you mean by "bouncing". Small up and down motions around home position? Full stroke of table movement up and down? Or somewhere in between? Does it start as soon as servo power is applied? Or not until table home movement is initi
Electronics Forum | Tue Oct 25 22:54:55 EDT 2005 | KEN
sorry. re-read your post. The problem is the home sensor relative to the home pulse. You're catching the wrong home pulse. a 10mm offset sounds about right for a 360 degree error. You need 50% +/- 15 % to ensure you always zero to the same phys
