Electronics Forum | Wed Feb 17 13:15:51 EST 2010 | jdengler
It turned out to be the battery in the CP-1 PLC. Replaced the battery and we are back up and running.
Electronics Forum | Tue May 22 09:37:11 EDT 2007 | jdengler
Hi Joakim, I do not know the QP242 table, but on our GP-341, CP-IV-2 and IP-III we make a plate from plexiglass with milled holes to show where the supports go for each board. This is not as fast as the Gridlock but does not cost nearly as much. J
Electronics Forum | Wed Feb 17 12:19:41 EST 2010 | cyber_wolf
Remove the HIMV-134 card. Unscrew the piggy back memory card and re-seat it. See if that helps.
Electronics Forum | Wed Jun 27 09:02:51 EDT 2018 | jdengler
A CP IV-3 is able to place 0402's very well. We do it all of the time with a CP IV-2. You need the right nozzles and feeders but no problem. I agree the ProSMT software is a pain but that's not the machine's fault. Jerry
Electronics Forum | Tue Feb 16 08:47:38 EST 2010 | jdengler
We powered up our CP-IV today and got an error. About 7 seconds after power on page 000 comes up with nothing in any of the areas except for second status area which contains "LD INIT" in yellow. After about 16 seconds the second display area gets
Electronics Forum | Wed Oct 10 11:20:31 EDT 2007 | jdengler
Do all 0201's reject at the same rate? If even 1 P/N has a lower reject rate this can point towards a feeder problem. I have had a similar problem on a CP-IV-2 with 0402's that was caused by feeders. If all reject at the same rate it can be the PD o
| 1 |
