Electronics Forum | Thu Apr 02 10:50:24 EDT 2015 | fnorradd
Hi All, Does anyone have any companies where I can purchase all the spares for JOT conveyors. Bearings, belts, motors, etc. Any feedback much appreciated.
Electronics Forum | Thu Oct 14 08:14:36 EDT 2010 | rway
We use both Panasonic and JOT. JOTs are a good conveyor. The Panasonics will probably cost you less. Check the used equipment market. That's where we got all of ours and I haven't had any issues with any of them except the normal where and tear o
Electronics Forum | Mon Mar 18 10:38:25 EDT 2013 | babe7362000
We are currently having an issue with one of our Jot Conveyors. The speed knob is on all the way (high setting), and the conveyor moves too slow and does not pass the sensor in time. Is there anything I can adjust to make the speed faster? Thanks
Electronics Forum | Tue Mar 08 11:21:32 EST 2016 | Colin
Hi all, Would anyone happen to possess a soft copy of the electrical schematics for the JOT 214-51.3 FIFO buffer conveyor? I would appreciate if anyone would be willing to gift a copy to me. Best regards Colin
Electronics Forum | Thu Apr 17 04:57:54 EDT 2014 | eoghan
Hi all, I posted this about a fortnight ago so apologies for reposting but I'm not too sure what else to do as I've searched everywhere. I've got an older Jot router J501-21 that has had a hard-drive failure and operating software is gone. I've been
Electronics Forum | Thu May 08 09:46:24 EDT 2008 | realchunks
Hello All, Who makes a shuttle that isn't over 4 feet long? Looking to install a new line and my current JOT shuttle is 6 feet long. I need something a little shorter, yet able to let people walk thru the line.
Electronics Forum | Thu Jun 08 21:56:41 EDT 2000 | Thomas Ravener
There are many available: Simplimatic Process Control Technology (PCT) JOT PMJ Bosch Dynapace Nutek Applied Conveyor Engineering (ACE) A wholly owned division of Universal Instruments and made for UIC integration of their products. This is just but
Electronics Forum | Fri Aug 17 09:42:18 EDT 2001 | Hussman
G'Day All, I have a couple of new Panasonic MSR's. Whenever I load a new program into the machine, I have to manually feed the first PCB onto the X/Y table to get it to run. After that, they run just fine. Panasonic is going to be in and they hav
Electronics Forum | Thu Nov 16 09:45:11 EST 2000 | DL
Where are the experienced operators? I'm sure they would have some good input to what it is you seek. How would this program you wrote know if the operators went to the bathroom during setup? Or took break? Or even waiting on incoming parts from ship
Electronics Forum | Tue Jul 27 10:43:08 EDT 1999 | Angie Vale
We currently have a single SMT line consisting of a Sanyo chipshooter in line with a Siplace 80F4 and we are soon going to install a odd form placement machine (probably JOT) into this line prior to the oven. This means going to intrusive reflow, whi
