Electronics Forum | Wed Apr 17 08:01:42 EDT 2019 | jfeustel
If this is a Kanetic edge belt conveyor that was manufactured by Kanetic in Lake Barrington Illinois then I've seen this before. The folks at Kanetic built a function into the PLC code to make the conveyor reversible without hardware modifications.
Electronics Forum | Tue Apr 25 13:05:08 EDT 2006 | Hoss
TMC, Are you interested in this approach because you only have a flat belt conveyor and want to keep the components from being moved by the belt on the second pass? If so, you might try adding some stiffeners to the board edges to stand the board o
Electronics Forum | Mon Aug 21 11:15:31 EDT 2006 | aj
All, We have a conveyor that uses an o-ring belt , this belt breaks quite regular which causes a hassle for the SMD Ops. The stuff we use is from Radionics,its 3mm also. Anybody recommend a good belt or procedure for joining them together( we curr
Electronics Forum | Wed Jun 12 14:36:15 EDT 2013 | rollon65
Hi Bert I had belts made for my conveyors using Habasit material made by Benson's belting here in U.K. They have been running now for 6 years or so and I am very satisfied with them. We are 12K miles away but check out their website at http://www.
Electronics Forum | Fri Apr 08 05:11:12 EDT 2011 | diputechem
you can use Rema tiptop's repair kit. if you think rema brand is very expensive. can use these tools made in China. The conveyor belt repair tools made by Dipute Co.,Ltd. is with good quality,low price,they have good reputation in Asia,and gained hi
Electronics Forum | Mon Apr 22 14:06:25 EDT 2019 | kgarlapa
Yes it is a Kanetic edge belt conveyor that was manufactured by Kanetic in Lake Barrington Illinois. I tried holding the reset/start button and also tried to cycle the power after after holding the reset button, No Luck.Do you know if Kanetic is sti
Electronics Forum | Fri May 05 03:38:02 EDT 2023 | ttheis
I am looking for some parts to repair a dyna-pace 1 meter conveyor if anyone has a scrap unit laying around. We just need the sheet metal edge strip as shown in the attached photo. Also looking for width adjust handles and a source for the 10mm wide
Electronics Forum | Fri Feb 27 11:22:46 EST 2004 | pjc
Contact Insertech N.E. Inc. at 978-433-3116. They are a used equipment supplier up in MA. I was in their shop recently and saw two wave exit conveyors- flat belt.
Electronics Forum | Wed Feb 08 22:22:31 EST 2012 | davef
Sounds like a sad story. Is it one of those belts that you can cut and then sew back together? Or are you figuring for all the work that you might as well replace it with something newer?
Electronics Forum | Wed Jun 12 08:33:39 EDT 2013 | emeto
Just measure width, length and thickness and buy from anyone that sells belts. This is just the website that comes on the top when I typed "conveyor belts" in google http://www.beltcorp.com/profile.html