Electronics Forum | Fri Sep 08 11:06:11 EDT 2006 | fabio
the video and the servo motors don't start... i need a wiring diagram to make the measures... please help!!
Electronics Forum | Sun Sep 01 22:02:58 EDT 2019 | sarason
Have you got a circuit diagram for your driver board? If not measure your driver into a resistive load and look for differences in current flow voltage drops under load dried out caps. Dead current measuring circuits etc. If you see an IC, look it up
Electronics Forum | Sat Aug 26 21:53:47 EDT 2017 | kieren
Hi Everyone. I am looking for some help with my Juki Ke750. The problem is that after booting up and then starting the home position function I receive an error as stated below Message File Error E0000: KEY=200078 STATUS=2 C:￥X750 ￥GX3ERROR。MSG
Electronics Forum | Wed Sep 05 06:34:08 EDT 2018 | oriolsancheza
Hi Rob, Thanks for your fast response. In fact, after a better look to driver boards, it has leaking SMD Electrolityc caps. Unfortunately after replacing them in 3 units, one of them gives 90% of times, ALARM4 led ON. Looks like a comunication pro
Electronics Forum | Mon Sep 03 07:17:43 EDT 2018 | oriolsancheza
Hello everybody, For a long time the Juki has been not used, but was working fine before that. Since 4 or 5 month ago, it brings some problems when initializing with T and Z Axes. Till now, just powering it off and on for a few times worked, but no
Electronics Forum | Mon Oct 10 15:24:15 EDT 2005 | zl3vlf
Hello to all! Our Fuji FIP-3 placement machine has come up with a servo alarm (X2-axis) whenever we try to run the machine. The manuals don't go into a lot of detail as to the cause of this problem, but there is plenty of information on what the X2
Electronics Forum | Mon Sep 26 18:46:37 EDT 2005 | stano
Hello. We have problem with MPA-V. Problem is with V1, V2 axis. Error is V1 AXIS MOVEMENT IMPOSSIBLE and V2 AXIS MOVEMENT IMPOSSIBLE. On the driver for this axis lighting error LED ST (sensor touble). It is problem in connection between motor encoder
Electronics Forum | Wed Nov 23 07:45:39 EST 2016 | bukas
hello, I have a GSM2 machine with faulty motor driver (i guess), usually when this error occurs i would rest it via button on a panel several times, but this time it doesnt work. what should i check/ measure to locate this problem? there is 7 blink
Electronics Forum | Wed Jun 03 21:49:27 EDT 2020 | bboyer
Well, we finally got the machine to power up and fully boot, but now we are having issues with zeroing the axes. X, Y and Theta zero OK, and the board conveyor runs, but when it tries to zero the PWC, the rail moves to the rear of the machine, hits
Electronics Forum | Thu Oct 04 00:03:28 EDT 2018 | gaintstar
flason smt pick and place machine: http://www.flason-smt.com/product/Hanwha-IC-placer-SM321-High-Speed-SMT-Modular-Chip-Mounter.html http://www.flason-smt.com/product/Hanwha-Pick-and-Place-Machine-DECAN-F2-High-Speed-SMT-Modular-Chip-Mounter.html htt
| 1 |
.png)
