Electronics Forum | Wed Mar 28 12:46:50 EDT 2007 | realchunks
Rob is right, you do need to dispense paste or pre-forms when using a laser. Although the Panasonic Soft Beam has a wire despenser. I've seen laser soldering and it does work on smaller stuff. Doesn't work well on connectors even after preheating.
Electronics Forum | Sat Sep 27 11:30:06 EDT 2003 | Fede Muelas
Hi, My name is Federico Muelas, I�m an artist working with technology and I�m having a solo show in Barcelona at the end of the year titled �the sound of the chocolate smell� where I�m showing my recent installation pieces, you can check the info of
Electronics Forum | Sun Jan 14 12:42:35 EST 2007 | SMTRework
I think the main cause of this condition is #3 because both #1 and #2 never change from board to board, these are identical boards with identical BGA revisions. These BGA's (as stated before) are about 3 years old.. I don't believe they are lead free
Electronics Forum | Fri Dec 08 19:08:52 EST 2000 | Mike Konrad
I do not know which specific flux you are using, but here are some general guidelines. If your wave soldering machine uses a foam fluxer, then there are foaming agents in the flux. Under �normal� conditions, the volatiles (including the foaming age
Electronics Forum | Wed Jun 24 23:52:41 EDT 1998 | Phillip Hunter
| Has anyone seen a problem with solder under chip components, in-between the glue and the component or in-between the mask and the component? We seen both. | What could be causing this? This has only been detected on one of our products. All the re
Electronics Forum | Wed May 06 15:05:00 EDT 1998 | Justin Medernach
| | Dear Freinds, | | DOES ANY ONE OF YOU WILL BE KIND ENOUGH TO GIVE SOME INPUT ON DOUBLE SIDE REFLOW OF COMPONENTS WHAT ABOUT BOTTOM SIDE COMPONENT HOLDING DURING 2ND SIDE REFLOW? ANY IDEA OTHER THAN USING SLDERPASTE WITH OFFSET MELTING POINT, EPOX
Electronics Forum | Tue Jul 03 01:54:42 EDT 2018 | rdhiman1
Reaching out to all conformal coating experts, please help! While setting up conformal coating using the automated atomized spray, we observing issues associated with conformal coating wetting on the following regions: 1) Component edges 2) Metalli
Electronics Forum | Thu Jan 11 22:01:09 EST 2007 | davef
Joe: I know this is not the correct forum to post chip "reworking" questions. Reply: Rework questions are as appropriate as the next topic here on SMTnet J: BGA will not reflow at any normal temperature level. I believe these chips may have been gen
Electronics Forum | Thu Jul 20 17:01:26 EDT 2000 | Bob Willis
Here is some further information on SDSRS process, but please purchase a copy of the report from t he SMTA as all the money goes to charity. In the UK the SMART Group raised over �3000 for the homeless. SMTA have been raising a lot of money for the G
Electronics Forum | Thu Jul 20 15:08:53 EDT 2000 | Bob Willis
Yes no problem here it is in a nut shell. The sponsor of my CD ROM on this process was Loctite who specifically developed a glue for the process to cure in less than 10seconds. Have a word with these guys they may even have a few CDs. PROCESS SEQUEN
