Electronics Forum | Sun Jul 09 09:54:21 EDT 2023 | recard
Hi guys. Maybe it helps someone. We solved almost all issues on our machine with changing the capacitors arround the processor on our motherboard. We first suspect the Power supply and decided to use two power supplies, one for the MB and the other o
Electronics Forum | Tue Mar 18 22:48:24 EDT 2008 | lectronix
We were told to turn on the air supply prior to turning on the power to the machine. We see this error when we forget to turn the air supply on first, you can just aknowledge the error and it will work.
Electronics Forum | Tue Aug 07 11:37:24 EDT 2012 | aadrian80
Could you please tell me how much have you paid for the elmo power supply,we talked with the tehnicians of mydata and they say we have to buy a new supply for our my19. Thanks!
Electronics Forum | Mon Sep 03 10:57:28 EDT 2018 | robl
Hi Oriol, Sounds more like a power supply/low voltage problem if all the driver cards are failing. Can you check if the PSU supplying them is stable? Rob.
Electronics Forum | Mon Aug 04 18:10:36 EDT 2003 | dougt
When a UPS is used on pick and place equipment is it setup to continue to run the entire machine or is it just keeping the computer(s) powered up? How long will the UPS typically supply power to the machine?
Electronics Forum | Wed Feb 11 06:37:10 EST 2009 | reflowtechnologies
Please check the following: 1.Power supply. 2.SSR control power. 3.OTP or over temp protection at the software. Maybe you set it at low so it reads over temp even at lower temp. If still not ok you may check BTU service engineers. Brian Riggs
Electronics Forum | Mon May 17 10:43:53 EDT 2010 | jaimebc
We are looking into adding an Uninterrupted Power Supply to our MYdata's pick and place, to protect the PC from power surges. I am looking for recomendations from current users. Thanks in advance.
Electronics Forum | Wed Jun 20 07:59:56 EDT 2007 | avalancher
The issue you are seeing is in fact the Battery that is in your machine. It looks like a motorcycle battery. It is usually located somewhere in or around your power supply. It should be reading an output of 18V. This battery is used in the event of a
Electronics Forum | Tue Feb 09 08:48:29 EST 2010 | davemacnemo
Machine has 2 FlexJets installed. Working fine until it started giving Theta1 following errors. Machine will not zero. Coincidental (I think) with this, the Low Power Power Supply behind the Power Distribution Panel failed and was rebuilt. It's worki
Electronics Forum | Thu Nov 19 21:34:09 EST 2015 | ttheis
We just powered up a used GSM1 for the first time and it seems to boot and initalize ok. It is running UPS 3.2.2c. The first thing we noticed upon initial power up is that there is a lot of 'noise' on the monitors. Is this normal due to being designe
