Electronics Forum | Thu Feb 22 11:33:24 EST 2007 | sliebl
We recently added an SPM printer to our SMT department and I need to buy some tooling pins and center supports. Other than MPM, is there any aftermarket support for this machine? Can anyone point me towards any suppliers for the above mentioned parts
Electronics Forum | Wed Mar 26 09:26:12 EDT 2008 | lloyd
I know you said you checked your clamps but another look will do no harm. we had a very similar issue a while back, and it turned out that the plastic shim under the chase clamp magnet was damaged. This caused the chase clamps not to release properly
Electronics Forum | Thu Feb 01 03:02:50 EST 2018 | robl
Hi Rob, > > I did check with the board house, and > the confirmed that there was no Nickel plating, > but that the silver went straight onto the copper > in their immersion silver > process. > > Interestingly I've even tested an > unplated sam
Electronics Forum | Sat Jan 22 15:11:50 EST 2000 | Ace
We had a set custom made for a fraction of the cost Camalot wants for them. Just take some measurements form your current set. It won't be too difficult.
Electronics Forum | Wed Mar 27 02:59:01 EST 2002 | ianccy
Hi, Don't know if some holes can be drilled to yur machine table, if so, yu can make the support with at least 2 pin and plug into the table, better to use aluminium support, easier to CNC. Hope this help
Electronics Forum | Thu Oct 03 10:02:08 EDT 2002 | davef
Your problem is likely not the Pd-Ag surface layers, but the underlying metal to which you need to wet. Either a base metal is: * Contaminated and poorly wettable. OR * A material [eg, Alloy 42 (check with magnet), Kovar, etc] that is inherently dif
Electronics Forum | Thu Sep 18 15:29:59 EDT 2003 | Gabriele
Hi all, by reading along those thread (SOT23) and Tan outgassing I learned plenty of things. My first time approacing this kind of Q$A Forum, very intesting tech communication way. Any way, the path of magnetism effect was chosen when time ago we met
Electronics Forum | Wed Jun 02 09:21:10 EDT 2004 | James
They take the place of the tooling pins. They magnetically attach to the table. Board comes in, table raises, Red-E-Set supports the board, prints, done. You just have to do the initial setup before running. We bought 4 units for each machine. J
Electronics Forum | Fri Mar 11 10:51:29 EST 2005 | mfoster
Samsung Back-up pins available from Dynatech for $30 each. http://www.DynatechSMT.com
Electronics Forum | Tue Apr 26 15:44:05 EDT 2005 | global
Thanks to all that replied but now I have a new problem. I actually did come across the gerber files............but there on reel to reel tapes. Does anyone know of a company that has the ability to read the magnetic reel to reel tapes and dump the f
