Electronics Forum | Wed Apr 10 22:15:58 EDT 2019 | kylehunter
So after listening to many people's options and thoughts, I have decided against novastar. There is a reseller near my office that offers full support, training, and service on used equipment. They also fully refurbish all equipment beforehand. I no
Electronics Forum | Tue Apr 23 06:26:18 EDT 2019 | jfeustel
Kanetic did implement a feature into their PLC code that would allow for simple reversal of the board flow. This is why the conveyor suddenly reversed direction after so many years. Because the feature was invoked by holding down a button it was kno
Electronics Forum | Wed May 08 18:04:02 EDT 2019 | slthomas
You would have to do some extensive testing to really now for sure how much better coated blades perform than OEM blades. Deciding whether or not they last longer is just a function of regular inspections under a scope and accounting for the number
Electronics Forum | Sat Jun 29 04:11:31 EDT 2019 | jackson_jade4
Well, I know that this is not directly related to the pycom device, but the code and load cell are connected to the device so I am hoping to gain from the wealth of knowledge and experience on this forum. Until a few weeks ago, I knew nothing at all
Electronics Forum | Mon Jul 08 12:21:17 EDT 2019 | slthomas
I forget which type of CTA that machine has so I probably won't be much help. It's been ages since I worked on them but it doesn't look like you'll find many people that have. That said, usually if you get things aligned properly and it still bends
Electronics Forum | Thu Jul 25 16:20:59 EDT 2019 | bobpan
Top red led is on or off depending on version of tep board. The green leds light when the transport sensor that it communitcates with is seeing a board over it. Tep controller init failure can be one of the following. 1. Check reseat tep card and
Electronics Forum | Mon Mar 23 15:08:21 EDT 2020 | slthomas
Unfortunately I didn't do the work...I just requested it from maintenance. I think the E5's were really a completely different beast than an E4, but I've never used an E4 so really don't have any experience. I purchased 3 E5's when new for a previou
Electronics Forum | Fri Oct 25 13:23:02 EDT 2019 | SMTA-Joe
Hello SMTA, This may be beyond the scope of the SMTA since it does not strictly deal with assembly of electronics, rather, it is about potential solderless methods for manually tuning RF circuits. Our Engineers & QC have tasked manufacturing with
Electronics Forum | Wed Dec 04 04:28:58 EST 2019 | oxygensmd
It seems there isn't right connection between solder and solder-legs. Maybe check that the LEDs get huminidity, have some oxidation on the legs, try different solder paste, check the reflow solder profile. On the photo I can not saw properly reflowe
Electronics Forum | Wed Dec 04 08:00:57 EST 2019 | kylehunter
Thank you both. We are using EP256 Solder Paste Sn63Pb37 no clean from Kester. I attached our profile as well as Kester's target profile. We used a populated demo board for the profile. We tested along the width, and was less than a 2c difference.