Electronics Forum | Thu Sep 23 01:54:54 EDT 2021 | auriga2001
We use nanocoating also on the stencils we purchase for our facility. It's easier to clean, there is less wear on the surface, and the solder paste releases better from smaller apertures.
Electronics Forum | Mon Feb 16 14:18:30 EST 2009 | jorge_quijano
1000 0402's, Micro BGA, QFP 0.4mm pitch, TSOP), we are trying to know what kind of equipment do you recommend to use in our factory, we already have Screen Printer, Chip shooters, Reflow oven, AOI, Stencil cleaner (manual), X ray, ICT... what else do
Electronics Forum | Mon Mar 02 10:23:46 EST 2009 | wrongway
You may need a glue despinser if you populate bottom side then wave. maybe a board deatacker at front of the line how about a multifunction pick and place machine so you can process all parts out there. we cleaned our stencils for years then we got a
Electronics Forum | Tue Oct 27 22:52:18 EDT 2009 | davef
Top picture: We're not wild about the 'poor registration,' the differing thickness of the solder mask, and the crud all over the board. But, then again, we don't have a basis for rejection. Bottom picture: No basis for rejection Help us out, what do
Electronics Forum | Wed Oct 28 07:26:19 EDT 2009 | julie331975
I don't like these boards for a couple different reasons. 1. They may be fine functionally but they look like crap. 2. What is our customer going to think when we deliver boards that look like this? They will probably wonder the same thing I do...
Electronics Forum | Thu Oct 29 18:33:18 EDT 2009 | comatose
The top picture probably won't run. You have black soldermask dramatically misregistered and overlapping what look a lot like fids. Either your machines are going to pitch a fit and not find the fid or they're going to center on the soldermask outlin
Electronics Forum | Tue Nov 03 06:23:12 EST 2009 | josh_brubaker
Has anyone ever done a tape test to see if the solder resist pulls away from the PCB? Is this an acceptable method for testing solder resist acceptability? This is an issue I am experiencing with our PCBs. I am receiving boards with excess solder o
Electronics Forum | Sun Nov 01 01:33:52 EST 2009 | isd_jwendell
Just my opinion: Top pic - Solder mask registration WAY too far off, without a doubt I would reject. Bottom pic - I would worry that there was/is a contamination that caused the poor looking mask. This may be cosmetic only, but unknown. I would rej
Electronics Forum | Tue Nov 03 18:09:17 EST 2009 | gregoryyork
I think most have summed up the first pictures also is the drillng looking like it is misregistered as well. Better to do a solvent test to determine resist cure not the old stuff the newer chemicals show under cure problem much better. Try your st
Electronics Forum | Fri Sep 02 11:26:50 EDT 2011 | steffenr
Overkill for sure! Program to BOM: Shouldn't have to verify the program to the BOM once it's been verified unless there is a change. Feeder to BOM" There should be some type of instruction that specifies that part goes on what feeder and where the