Electronics Forum | Thu Oct 21 23:20:05 EDT 2010 | camtechpcb
According to the Trichromatism.Half red and half blue will get purple.But the trichromatism only apply to color light. The red and blue soder mask are coloring material.Both of them absorb light.You mixed them up,so you lose blue and red,and get grap
Electronics Forum | Tue Nov 22 19:32:27 EST 2011 | kenkay
We are looking for a new machine to replace our Asymtek C-708 that we use for wave masking. Asymtek offers a D-585 but we were looking for something better then a table top unit. Any recommendations on a company or machine? Thanks
Electronics Forum | Wed Jul 06 09:28:00 EDT 2016 | smtbroker
Hi Pavel here in Poland interflux sells a product C8 who can remowe the solder mask, no disolve. It is a high alcalin product with other stuff, you can ask to vsd@interflux.pl jean vadim
Electronics Forum | Wed Jul 06 16:08:17 EDT 2016 | davef
Circuit Technology Center “4 Techniques for Removing Solder Mask” [http://www.circuitrework.com/features/607.shtml]
Electronics Forum | Wed Nov 20 01:38:53 EST 2019 | ajspec
Hi, i'm facing solder mask peel off but limited to the solder defined pad only(opening area). no peel off on the other area and it happened on electroless nickel immersion gold finishing only. for other finishing is not affected. kindly advise if you
Electronics Forum | Tue Dec 10 13:35:34 EST 2019 | scotceltic
I am looking to see what people are using for a min-max range to supply your PCB fabricators regarding solder mask thickness. I saw some points in the archives but not too much regarding what people are providing as their spec ? Any help would be a
Electronics Forum | Wed Aug 17 13:57:27 EDT 2005 | ppwlee
We have encountered what appears to be mask discoloration after wave soldering. The areas of concern coincide with the areas that were exposed selectively by fixtures during wave soldering, dominated by one date code of PCB with a slightly different
Electronics Forum | Tue Dec 17 11:01:24 EST 2002 | Tim Marc
Hello all, One of our PCB manufacturers coated a through hole connecters vias with solder mask. The only IPC references that comes close to describing this problem is 2.9.2 Registration to holes, and subsequent specification 6.3.1 PTH � Vertical fil
Electronics Forum | Wed Jul 06 09:07:28 EDT 2016 | davef
Hi Pavel IPC-6012 - Qualification and Performance Specification for Rigid Printed Boards, Paragraph: Solder Resist (Solder Mask) Requirements, Sub-paragraph: Solder Resist Thickness has words to the effect … * Solder mask thickness shall be accordi
Electronics Forum | Thu Jul 05 21:42:28 EDT 2001 | davef
Most of our boards are fabricated with solder mask over bare copper [SMOBC], but we have couple where the solder isn't removed before masking. And ever so offin they's a liddy bit mo' solder than we'd like, which when reflowed, ends-up connecting so
