Electronics Forum | Fri Jun 02 17:43:17 EDT 2000 | Dave F
James: I believe Delmat is a proprietary product. Check with some of the solder fixture fabricators in the archives. Continuing, I would not select knowingly Delmat as a board stiffener. It's a composite material similar to oriented strand board
Electronics Forum | Fri May 31 12:28:45 EDT 2019 | slthomas
You really need to define what you mean when you say "bend" and when you say "break". You might have zero damage to a bare board but cracked solder joints and ceramic caps on an assembly, given the same amount of bending or stress. It all depends on
Electronics Forum | Thu Sep 02 16:52:31 EDT 1999 | Earl Moon
| | | Has anyone done or seen any studies done documenting what may be the affect of hardware such as screws in the parimeter vicinity of BGAs on a circuit board? | | | | | | What I'm really after is anything describing how close a screw/washer/nut
Electronics Forum | Tue Aug 26 13:28:50 EDT 2008 | qaman
I am new to the board so be gentle with me. There are standards such as IPC-610 for PCB assembly, IPC-600 for bare boards, etc. Is there a "standard" for electro-mechanical assembly? Is there an IPC standard or any other industry approved standard
Electronics Forum | Tue Sep 02 13:30:05 EDT 2008 | evtimov
I am new to the board so be gentle with me. > There are standards such as IPC-610 for PCB > assembly, IPC-600 for bare boards, etc. Is there > a "standard" for electro-mechanical assembly? Is > there an IPC standard or any other industry > appro
Electronics Forum | Sun Aug 05 01:31:08 EDT 2012 | dws123
printed circuit board assembly used to mechanically support and electrically connect electronic components using conductive pathways.it is a electronic device made by copper.it is a cheaper and useful .so we used in electronic devices.
Electronics Forum | Tue Jan 09 15:26:49 EST 2018 | emeto
The truth is that TH will give you better mechanical stability. If it is a part where you risk strip off the pads of SMT connector, don't make this transition to SMT. If it is a one time cable plug there and there will be not too much pressure, go fo
Electronics Forum | Wed Jan 10 05:54:31 EST 2018 | tozitom
Thanks to all for your quick answers. I will do a prototype to test mechanical stability on USB-A, SMT version and will decide the next steps for there. Best Regards.
Electronics Forum | Tue Jan 09 17:37:00 EST 2018 | tozitom
The truth is that TH will give you better > mechanical stability. If it is a part where you > risk strip off the pads of SMT connector, don't > make this transition to SMT. If it is a one time > cable plug there and there will be not too much >
Electronics Forum | Wed Jul 21 10:11:57 EDT 1999 | Mark Quealy
| | Dear all | | Please help me to know what kind of tests usually done after SMT Pick & place and reflow oven. | | Our appliocation is Mainly fabrication of mother boards. | | Thanks | | | In theory, ICT is the classical answer (In-Circuit Test).
Golden State is a contract manufacturer that makes wire harnesses, electromechanical assemblies (box builds, subassemblies, PCBAs, kits, etc.) and services (sorting, rework, value additive manufacturing engineering)
18220 Butterfield Blvd
Morgan Hill, CA USA
Phone: 5102268155
