Electronics Forum | Fri Jan 28 13:34:18 EST 2011 | rodrigo
Hi all, I just finished programming a board in this AOI machine and I'm getting the same IC rejected in every board with this error: Inspection window out of frame range. I don't know how to fix this because the frames get generated automatically
Electronics Forum | Thu Aug 18 09:41:05 EDT 2016 | jbuckley
Typically on my company's Mirtec systems, any anomalies, such as cracks, chips, etc. on chip capacitors and chip resistors are going to be detected with just a basic mounting inspector. We have a full image of the part (solder joint not included) as
Electronics Forum | Tue Jan 11 13:12:58 EST 2011 | methos1979
Has anyone had any luck programming using the side cameras to inspect for defects on the sides of chip components? We recently had an escape of a damaged chip capacitor that was impossible to see from the top camera but was clearly visible with the
Electronics Forum | Mon Feb 07 18:12:56 EST 2011 | eadthem
I do not know what software version you have, but on older versions it is best to have a mounting inspector set to be the primary and then mask out all labels and solder so it just locates the part. Then add another mounting inspector for looking at
Electronics Forum | Thu Feb 07 12:37:42 EST 2013 | phase1
Resistor/Caps using package library Match-45% White pixel solder-25% search window-25% Tant caps custom teach checking for pattern/value Do you also put a polarity band check in there or just check the value and click the polarity box? same passing
Electronics Forum | Mon Jan 10 18:35:05 EST 2011 | eadthem
Ive used a Mirtec machine for 3 years MV3L with side angle inspection. Mirtec has some issues documentation, and repair plus. But there machine is impressive and the AOI software is good. We can find about 90-99.99% of all errors using just the 5
Electronics Forum | Tue Feb 17 09:33:43 EST 2015 | emeto
Hello, I have two of these for the last 3 years(MV-7xi). Buy the machine with the best camera they offer and with the telecentric lens - it gives great view and resolution. I had to replace the controller for conveyer open/close on both of them. I a
Electronics Forum | Mon Oct 20 10:08:42 EDT 2014 | rgduval
Had someone in from the broker that we bought this machine from, and he did some poking around. We've learned some things, but, unfortunately, are still no closer to getting the machine running :( We discovered (based on double checking other machi
Electronics Forum | Wed Jan 18 12:57:22 EST 2006 | cyber_wolf
Since I have posted on this last, we have found that 99% of our nozzle sticking problems are do to part height problems. I have been told that CP6 machines are very sensitive to part height do to the amount of spring travel in the nozzle. If you hav
Electronics Forum | Sun Jan 16 05:22:36 EST 2005 | dorklover664
I�ve worked as an SMT operator for 3 different companies. And have worked with six different types of pick and place machines. I can tell you what I know. The first place I worked at was high volume low mix and we ran Fuji�s. They are by far the best
