Electronics Forum | Tue Oct 23 09:21:44 EDT 2018 | bobpan
What files should we backup in case of a hard drive failure on the momentum printer? Software is 3.6.1. Thanks
Electronics Forum | Fri Dec 14 19:56:40 EST 2018 | denisss
Good afternoon, the problem gives an error vision gantry x, an error occurs after the camera approaches the car wash and hits the piston, what could be the matter? are there any real specialists gives an error after a certain working time of 40 minut
Electronics Forum | Thu Nov 07 17:01:05 EST 2019 | tmcnamara
Hi all does anyone happen to have a manual for the accuflex momentum printer
Electronics Forum | Tue Jan 15 11:47:18 EST 2019 | emeto
Hi, I personally use my checkplot files to teach paste inspection machines. These should already be in the right view so you can treat them as individual top sides(no flip needed for both sides)
Electronics Forum | Mon May 09 21:07:53 EDT 2022 | kurtiss
Currently we have a line running a MPM Accuflex. We are working on setting up a second production line and are in need of a new stencil printer. The two machines available within budget are a MPM Momentum and a Ekra X6. We have been happy with the MP
Electronics Forum | Tue Jan 15 14:11:12 EST 2019 | griinder
I also use these when available. The problem still persists for Bottom Paste/Parts layer. The non-symmetric(x axis) footprints in the Btm part layer, display correctly in the software, But then display incorrectly when imported into the Printer. The
Electronics Forum | Mon May 13 13:45:33 EDT 2019 | whitelancer64
I am having the same problem with the MPM Accela solder paste printer machine. If the fiducials are adjusted for PCB alignment, the location of the paste is then wrong, and vision inspection fails. This is a problem for both pad preview inspection
Electronics Forum | Tue Jan 15 10:08:19 EST 2019 | griinder
I'm looking for any experienced Graphicode software users for advice. We use Gerber EZ Teach(GC Powerplace) to offline program 2D inspection on our Momentum printers. I have an issue with mirrored apertures when creating my Bottom Side inspection pro
Electronics Forum | Wed Mar 27 13:47:24 EDT 2019 | whitelancer64
I am having an issue with aligning vision for solder paste inspection with the PCB in the Momentum machine. The SMT operators setup the profile on the machine, which I then import into Aegis CircuitCAM to add PCB locations. But when I export again, t
Electronics Forum | Thu Oct 20 12:33:39 EDT 2016 | cyber_wolf
We get our fids laser etched and never have fid read problems. They are black. (see attached) All of our printers are Momentums. Half etch and fill is old school. I used to take 2 part epoxy and mix black printer toner into it and squeegee the mi
.gif)
