Electronics Forum | Wed Apr 30 16:00:12 EDT 2008 | tech13108
Hello, We have recently purchased an older MPM via auction and I am trying to get it running but not getting too far. When I power it up it goes thru a boot sequence then a screen appears on the monitor with a "warning cover not closed, close cov
Electronics Forum | Fri May 01 15:35:03 EDT 2020 | travishemen
I'm not sure if these are similar to our Genesis machines but if they have removable feeder banks they are part of the safety circuit. If they are not installed or if the sensors on them are misaligned it will show the same as an interlock violation
Electronics Forum | Thu May 01 07:33:19 EDT 2008 | realchunks
Jim, You need to repair or by-pass the cover interlock. The machine thinks it's open and will not procede any further. They all do it, even the new models. Once you get past this warning - you will get the the RESET window - garanteed.
Electronics Forum | Mon Feb 20 15:28:15 EST 2017 | fuzz
Hi guys. I'm dealing with 3 MPM Ultraprint 3000 machines in our plant that were showing different issues. I managed to solve most of them but one is killing me and I can't seem to solve it. It's a 3000 HiE model... Basically, the machine seems to be
Electronics Forum | Mon Sep 03 21:33:41 EDT 2018 | aemery
Jeff R, The "24VS" stands for 24VDC Voltage Switched; meaning that it is supplied under machine control and other things have to happen in the machine before 24VS is applied, in this case to KP1 coil. KP1 coil/contact is in place as part of the pow
1 |