Electronics Forum | Fri Oct 04 14:15:21 EDT 2019 | ddfreeze
that doesn't seem to be the issue here
Electronics Forum | Fri Oct 04 13:47:25 EDT 2019 | compit
I had as I placed the supports at the back - when lifting Z touched the rear rail - check.
Electronics Forum | Thu Oct 03 18:00:51 EDT 2019 | ddfreeze
Got a used mpm up2000. It gives z axis hardware limit warning when trying to teach vision. The board raises to camera then drops back down. However when loading a board for tooling, the board stays raised up. The z table can be manually raised up n d
Electronics Forum | Wed Dec 04 08:02:02 EST 2019 | proceng1
Contact George Castonguay at PPM. He is a Jedi when it comes to these machines. In fact, since you just got it, a good investment would be to have George come in and go through the machine and get it calibrated. 603-895-5112 They also sell parts
Electronics Forum | Tue Dec 09 11:40:38 EST 2008 | dwl
Hello, I have an MPM AP 25 and the camera parks itself over the worknest, so when the z tower tries to rise to print, it collides with the camera. Is there some way to adjust the park position so that the camera in not in the way of the Z tower? Than
Electronics Forum | Mon Oct 07 16:07:22 EDT 2019 | ddfreeze
I have a silver aluminum z axis sensor that is not mounted, I need to know where it goes. The sensor has a picany rail type mount, triangular rail insert type. It is located in the board support nest area. Seems like it might go on the inside of the
Electronics Forum | Tue Aug 15 10:55:23 EDT 2006 | chrisgriffin
Some software versions won't allow a brightness change with the next button. You should do a histogram test. Place a board on the worknest, then a smooth white card on top of that. Then jog the camera over the card. Raise the Z-axis to it's softwa
Electronics Forum | Wed Apr 08 18:47:57 EDT 2009 | swag
Could be the z-axis driver card???
Electronics Forum | Mon Apr 13 16:06:36 EDT 2009 | soudomphong
I thought AP-25 was old. Good luck!
Electronics Forum | Mon Jun 19 13:00:16 EDT 2006 | fabio
"Z tower obstruction - machine must reset". I�m having this problem in the machine... please help!!
