Electronics Forum | Mon Feb 06 07:20:12 EST 2017 | prdmm1
2010 component. and the vacuum pressure is good. using an A14 size tool. tried a smaller tool as well. wondering if it could be the coating the company uses to make the print on the part. maybe its not even or something?
Electronics Forum | Tue Feb 03 12:39:16 EST 2009 | markhoch
Not sure what your job quantity is, or how many total parts you have to place, but we've had similar issues in the past trying to place domed LEDs. We had better luck cutting the tape into 25 or 50 piece strips and using double-sided tape to put the
Electronics Forum | Sat Jan 29 04:59:02 EST 2005 | Grant
Hi, MYDATA's are ok for lower volume, and they are very flexible. If you only have 1 or 2 trays of components and are on a tight budget, then you can even place the trays on the Y wagon behind the PCB so you can get away without the tray wagon. Al
Electronics Forum | Tue Jun 08 22:30:05 EDT 2021 | vtdivtecs
So I am having a little trouble with my mydata MY19. its an older machine picked up used and its had its quirks. recently we tried to start adding electrical verification to our workflow, and had to disable it as we were getting intermittent bad pa
Electronics Forum | Thu Jan 07 15:48:03 EST 2016 | ahanna
Hey everybody! So my Quad 4000c has been acting funny lately. When it goes to dumb a rejected part into the dump bucket it doesn't actually drop the component. This results in it trying to pick up another part with the previous part still on the nozz
Electronics Forum | Mon Jul 29 13:34:28 EDT 2013 | dontfeedphils
Usually the reason it will fail a part like that when you are using mechanical centering is because the part is usually picked so off center because of the body shape. So when the centering jaws close to push the part to center they give up and fail
Electronics Forum | Fri Jul 26 11:20:33 EDT 2013 | gnus
Hi all, I'm having issues placing 7 pin DPak packages. I'm using mechanical centering with four centering phases (one for each orientation). Tool used is A24S. Machine picks up the part but will reject it when centering the part. I have measured all
Electronics Forum | Tue Jul 30 11:58:50 EDT 2013 | gnus
Seems to pick up and place fine now. No idea why, didn't change a thing. Thanks for the advice everyone!
Electronics Forum | Tue Dec 21 12:28:11 EST 2021 | vtdivtecs
hey all, I had a comically bad failure yesterday while working with my pick and place, a part got dropped at exactly the wrong moment and flung a bracket up into the tool path, severely damaging the hydra controlboard that is next to the x camera. T
Electronics Forum | Mon Aug 01 19:43:08 EDT 2022 | emeto
I would assume it can do under some conditions. If you manually go and define pick up positions for all parts, may be there is not a good distance between two parts to pick at the same time. There also might be ON/OFF menu for this option.
