Electronics Forum | Tue Feb 28 08:19:03 EST 2012 | cyber_wolf
Replace both of the big X-wagon ribbon cables to start with. You always have to rule those out before looking at anything else.
Electronics Forum | Mon Feb 27 23:02:55 EST 2012 | ev
We have a TP-11 and this error occurs at the start of the insertion pattern hence we can't run. Any suggestions for correction? Thanks, Ev
Electronics Forum | Tue Feb 28 07:31:40 EST 2012 | bk
I'm assuming it's your x wagon tranducers that are out of synch. So the first place to start is look at your couplings on both x motors and make sure one of them isn't broken or starting to break. After that i would try swapping out your x board with
Electronics Forum | Mon Aug 21 11:38:20 EDT 2017 | smdbert
Hello , How to solve this problem. Thnxs Bert
Electronics Forum | Wed Aug 23 11:06:57 EDT 2017 | cyber_wolf
Bad Z-force sensor or it is checking the board height in a hole.
Electronics Forum | Thu May 26 13:53:45 EDT 2005 | gregp
I wouldn't worry about patents except for those types of feeders which have patents such as the MyData Agilis feeders. I would worry about cost of tooling for $tampings. Long time for ROI there. Also pay attention to the burr side and shear side of
Electronics Forum | Wed Mar 20 13:18:26 EDT 2013 | kmots15
Is printing your concern or placement. I would say both: Printing: At 5 feet and on a flex you better have a really nice fixture to keep everything in check. You'll probably have to hand screen it unless your going to get a dedicated custom continu
Electronics Forum | Fri Oct 03 07:49:19 EDT 2008 | grantp
Hi, I just saw the new NXT machines at globaltronics in Singapore, and mostly they are faster. However what was interesting is Fuji shows a prototype of the new XPF machine, but it was called XPF-W which handles really large PCB's and uses the sam
Electronics Forum | Sat May 05 21:26:31 EDT 2007 | bkgsmtnet
Who services your MYDATA machines? Do you have to have your software registered to get service? Are there independent field service techs out there? thx b
Electronics Forum | Fri May 11 09:51:52 EDT 2007 | rgduval
We use MyData direct up here in the New England. Always seemed easiest to me. In a previous life, I did use an independent contractor. She used to work at MyData and serviced my machines in an even more previous life. Then branched out on her own